Hotpoint Integrated Dishwasher Installation Instructions

Product Dimensions and Requirements

The installation requires a cabinet with specific dimensions. The height of the cabinet can be adjusted between 820-900 mm. The width must be a minimum of 600 mm, and the depth a minimum of 560 mm.

The dishwasher unit has a maximum height of 760 mm and a weight capacity for items placed on top is between 3-10 kg.

Required Tools and Components

The following tools and components are necessary for installation:

• Gloves
• Screwdrivers (Phillips head and flathead)
• Spirit level
• Pliers
• Measuring tape
• Screws: 4x Ø4x38 mm, 4x 3.5x18 mm, 2x Ø4x25 mm
• Service information sticker

Installation Steps

Step A: Preparing the Cabinet

Ensure the cabinet is prepared according to the specified dimensions. Adjust the height if necessary using the provided adjustment mechanisms.

Step B: Positioning the Dishwasher

Carefully slide the dishwasher into the prepared cabinet space. Ensure it is aligned correctly.

Step C: Securing the Dishwasher

Use the provided screws to secure the dishwasher to the cabinet. Follow the diagram for precise screw placement.

Step D: Adjusting and Leveling

Adjust the leveling feet of the dishwasher to ensure it is stable and perfectly level. Use a spirit level to confirm.

Step 1: Attaching Side Panels

Attach the side panels of the dishwasher, ensuring they are flush with the cabinet.

Step 2: Securing the Top Panel

Secure the top panel of the dishwasher using the appropriate screws.

Step 3: Installing the Front Panel

Attach the front panel or door to the dishwasher, aligning it with the cabinet.

Step 4: Connecting Water Supply

Connect the water inlet hose to the water supply. Ensure the connection is secure and leak-free. The water pressure should be between 0.05 MPa (0.5 Bar) and 1 MPa (10 Bar).

Step 5: Connecting Drainage

Connect the drain hose to the household drainage system. Ensure the hose has a proper siphon loop to prevent backflow.

Step 6: Electrical Connection

Connect the dishwasher to a grounded electrical outlet. Ensure the power supply meets the requirements specified in the manual.

Step 7: Final Checks

Perform a final check of all connections and ensure the dishwasher is stable and level. Refer to the diagrams for specific checks on door alignment and sealing.

Step 8: Water Hose Routing

Ensure the water inlet hose is routed correctly, with a minimum length of 400 mm and a maximum of 800 mm from the unit to the connection point. The drain hose should be positioned with a minimum height of 400 mm and a maximum of 800 mm from the floor.

Step 9: Door Panel Attachment

Attach the decorative door panel to the dishwasher door, following the specific instructions for alignment and securing.

Step 10: Final Placement and Connections

Ensure all hoses and cables are correctly routed and secured. The inlet hose should be approximately 1300 mm, 1500 mm, or 1500 mm depending on the configuration. The drain hose should also be routed appropriately. Ensure the waste pipe connection has a minimum diameter of 25 mm.

Service Information

For service-related inquiries, please refer to the service sticker provided with the unit.