Instruction Manual for CARAUDIO-SYSTEM models including: TF-LR12, TF-LR12 Video in Motion Interface, TF-LR12, Video in Motion Interface, Motion Interface, Interface

TV-Free TF-LR12 for Landrover and Jaguar touch-screen navigation systems version 3 since 2012


File Info : application/pdf, 5 Pages, 380.19KB

PDF preview unavailable. Download the PDF instead.

man eng TF-LR12 TV-400
TV-Free
Video-in-motion Interface
TF-LR12
for Landrover and Jaguar touch-screen navigation systems version 3
since 2012

Legal Information
By law, watching moving pictures while driving is prohibited, the driver must not be distracted. We do not accept any liability for material damage or personal injury resulting, directly or indirectly, from installation or operation of this product. This product should only be used while standing or to display fixed menus or rear-view-camera video when the vehicle is moving, for example the MP3 menu for DVD upgrades.
Changes/updates of the vehicle's software can cause malfunctions of the interface. We offer free software-updates for our interfaces for one year after purchase. To receive a free update, the interface must be sent in at own cost. Labor cost for and other expenses involved with the software-updates will not be refunded.

Version 13.07.2012

TF-LR12

Contents

1. Prior to installation

1.1.

Delivery contents

1.2.

Check compatibility of vehicle and accessories

1.3.

Setting the Dip-switches of the CAN-Box TV-400

1.4.

Pin-assignments

2. Installation

3. Activation of the video-in-motion function

4. Specifications

5. Technical support

1. Prior to installation
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources.

1.1. Delivery contents

Take down the SW-version and HW-version of the interface boxes, and store this manual for support purposes.

CAN-box TV-400 HW_____ SW_____

Harness TV-LR02

Page1

Version 13.07.2012

TF-LR12

1.2. Check compatibility of vehicle and accessories

Requirements Vehicle
Navigation

Jaguar XF X250, Jaguar XJ X351 (2011- ), Land Rover Range Rover Evoque L538, Range Rover Sport, Discovery 4 from year 2012
Touch-screen navigation version 3

1.3. Setting the Dip-switches of the Can-Box TV-400

Jaguar, Land Rover with rear-view camera

Dip 1 ON, dip 2 ON, dip 3 ON

Land Rover without rear-view camera

Dip 1 OFF, Dip 2 ON, Dip 3 ON

Note: On Land Rover setting dip 1 to ON codes the factory rear-view camera input which is located on the brown Fakra male connector of the factory monitor. When reverse gear is engaged, the navigation will automatically switch to this input. On vehicles with factory rearview camera set Dip 1 to ON, too.

1.4. Pin-assignments

Pin-assignment factory monitor connector

Cable colour  Orange/grey  Orange/purple

Assignment CAN-HIGH Pin 2 CAN-LOW Pin 1

No liability for vehicle wire colors and pin definition! Possible changes by the vehicle manufacturer. The given information must be verified by the installer.

Page2

Version 13.07.2012

TF-LR12

Pin-assignment of the CAN-Box TV-400 (Molex 8pin)

 Red  Black  Yellow  Blue  Yellow/Black  Blue/Black

+12V battery power Pin 4

Ground

Pin 8

CAN High Navi

Pin 1

CAN Low Navi

Pin 2

CAN High Vehicle Pin 5

CAN Low Vehicle Pin 6

2. Installation
Switch off ignition and disconnect the vehicle's battery! If according to factory rules disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead.
Place of installation is at the back of the factory monitor.

3. Activation of the video-in-motion function
The video-in-motion function is activated permanently without disturbing the navigation performance.

Page3

Version 13.07.2012

TF-LR12

4. Specifications

Operation voltage

10.5 ­ 14.8V

Stand-by power drain

<2mA

Operation power drain

~60mA

Power consumption

~0,08W

Temperature range

-30°C to +80°C

Weight

44g

Measurements (box only) B x H x T 70 x 20 x 47 mm

5. Technical Support

Caraudio-Systems Vertriebs GmbH manufacturer/distribution Rheinhorststr. 22 D-67071 Ludwigshafen am Rhein

NavLinkz GmbH corporate sales/tech dealer-support Eurotec-Ring 45 D-47445 Moers

phone +49 180 3 907050 email support@caraudio-systems.de

Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ® of their corresponding legal owners.

Page4

Version 13.07.2012

TF-LR12



References

Microsoft Word 2019 Microsoft Word 2019