Aspire AVP-CUBE User Manual
Innovate the way you vape
Safety Information
For a safe and effective use of this product and its accessories, please read the following instructions in full and strictly observe the operating procedures indicated in this manual. Refer to the leaflet contained in the packaging of individual products/accessories.
This product is intended for adult smokers. It is not recommended for non-smokers, young people under the legal age, pregnant or breast-feeding women, and individuals experiencing general ill health.
Keep the product and its accessories out of reach of children and minors at all times!
Components of the Product
The AVP-CUBE is a high-tech product. Its components, such as the battery, the Type-C cable, and the pod, are specifically made for this product. We recommend the exclusive use of components and accessories indicated. Using components and/or accessories not specifically produced for this device may lead to malfunction and/or damage to the product, and may void the warranty.
Warnings Before Use
Using an empty, dry, or drained tank/pod can cause immediate damage to the internal resistance and consequently void the warranty.
General Warnings and Limitations of Use
- Do not bring your vape device into contact with water or other e-liquids.
- Avoid exposing the device to extreme temperatures (below -5°C or above 50° C).
- Avoid using the product in overheated or excessively damp environments.
- Keep the product and its accessories away from heat sources.
- Use only Aspire original spare parts and accessories.
- Always discharge the battery completely before recharging.
- Carefully read the composition of the e-liquid before use. Do not use the product if you are allergic to any e-liquid components.
- Do not use the product if you have respiratory and/or cardiovascular disorders.
- Do not use the product during pregnancy or lactation.
- Do not ingest or swallow any part of the product or its accessories. Do not attempt to open or tamper with the components of the product or its accessories.
- The device does not require a flame to operate.
- To avoid performance loss, disconnect the battery from the USB charger when fully recharged. In case of anomalies, smell of burnt, or abnormal deformation of any component, stop using the device immediately and contact Customer Care.
- Avoid direct contact of e-liquid with the mouth, which can occur if you inhale too strongly or too frequently, or if the tank is overfilled.
- Avoid any unauthorized operations that may damage the product.
- For optimal performance, wait at least 30 seconds between inhalations.
- We recommend using only the Aspire charger for this device. Do not attempt to recharge the device with any other type of charger.
- Do not use the product while charging.
- Do not discard this product into the environment. Dispose of product components at designated collection/disposal points.
Safety Note
To avoid accidental firing, always ensure you lock or switch off your device when it is not in use, especially when carrying it in your pocket, bag, or purse.
Contents
- 1* AVP-CUBE Device (1300 mAh)
- 1* AVP-CUBE Pod (3.5 ml)
- 1* AVP Pro Standard Coil 1.15Ω
- 1* AVP Pro Mesh Coil 0.65Ω
- 1* Type-C Cable
- 1* User Manual
Components View
Drip Tip
Pod
Coil
Airflow Holes
Fire Button
Indicator Light
Type-C Charging Port
Ventilation Holes
Specifications
Pod capacity: 3.5 ml
Built-in battery capacity: 1300 mAh
Dimensions: 110*22*22 mm
Adjustable airflow
Coil parameters:
- 0.65Ω 15-18W Kanthal AF (Mesh coil)
- 1.15Ω 10-16W Kanthal AF
Easy bottom fill
Output mode:
- 1. Bypass output (when the resistance is less than 1.0Ω)
- 2. Optional output wattage: 10W, 12W, 14W, 16W (when the resistance is equal or higher than 1.0Ω)
Pod Filling
Note: When using a new coil, let the pod sit for 5 minutes after filling so the cotton can be saturated with e-liquid before use.
Do not let the pod become completely empty. Refill the pod to avoid dry burning or damage to the coil.
Coil Installation
Detach the pod
Lift the silicon seal and replace the used coil
Insert the pod back
How to Adjust the Airflow
To adjust the airflow, detach the pod and align the airflow channel with each of the four sides of the mod. Each side will activate a different airflow level.
Instructions
Device | Status of indicator light |
---|---|
Connect/disconnect the pod | When the resistance is ≥1.0Ω, the light will flash 2 times. When the resistance <1.0Ω, the light will flash sequentially green, blue, and then red. |
Click the fire button 5 times quickly to turn the device on or off | It flashes white 3 times |
Battery level > 3.8V (60-100%) | Green |
Battery level = 3.5-3.8V (30-60%) | Blue |
Battery level < 3.5V (0-30%) | Red |
Quickly press the fire button twice to set the output wattage | The light will flash in different colors 3 times to indicate the level of output wattage: Flashing white is 16W Flashing green is 14W Flashing blue is 12W Flashing red is 10W |
Note: The output wattage can only be selected when the resistance of the connected coil is detected to be equal or higher than 1.0Ω; when the coil's resistance is less than 1.0Ω, the output mode is automatically in bypass mode; therefore, it cannot be adjusted. If you press the mode button twice, the LED light will flash sequentially red, blue, and green to indicate that the output wattage cannot be adjusted.
Protective Features
Feature | Indicator Light Status |
---|---|
Vaping Over-Time Protection (10s) | The LED light will flash pink 10 times |
Short Circuit Protection | The LED light will flash pink 3 times |
Low Voltage Protection | The LED light will flash red 15 times |
Overcharge Protection | The device will stop charging |
Over Heat Protection | The LED light will stay yellow for 3s and then the device will cut off |
Charging Instructions
Parameter | Value |
---|---|
Maximum charge current | 2A |
Recommended charge voltage | 5V |
LED Light flash green 20 times | Fully charged |
LED light flash red 3 times | Attach the Type-C cable |
LED light flash green 3 times | Unplug the Type-C cable |
Important Information About Using Nicotine Containing E-Liquids
Before using nicotine-containing e-liquid, please read the following information carefully.
Nicotine Containing E-Liquid:
Do not use if you are allergic to nicotine or any other ingredients contained in the liquid. Verify the liquid's label before use.
Warnings and Precautions:
Nicotine-containing e-liquids are not recommended for:
- Non-smokers
- Young people under the legal age
- Pregnant or breast-feeding women (nicotine is known to cross the placenta and be excreted in breast milk)
- Individuals with general ill health, such as heart disease, stomach and duodenal ulcers, liver or kidney problems, chronic throat disease, or breathing difficulties due to bronchitis, emphysema, or asthma
- Individuals with an overactive thyroid gland or pheochromocytoma (adrenal gland tumor affecting blood pressure)
- Individuals with diabetes (nicotine may affect blood sugar levels)
- Individuals taking the following medications: Theophylline (for breathing problems), Ropinirole (for restless leg syndrome), Clozapine (for schizophrenia)
Possible Side Effects:
If you inhale too much nicotine or use the product excessively, you may experience one or more of the following effects:
- Feeling faint
- Nausea (feeling sick)
- Headache
- Coughing
- Irritation of the mouth or throat
- Dizziness
- Stomach discomfort
- Hiccups
- Nasal congestion
- Vomiting
- Palpitations
- Abnormal heart rate
If you experience any of these side effects, including any not listed, discontinue using the product. If side effects persist after stopping use, consult your doctor or healthcare professional and bring this leaflet.
Warranty
Please visit our official website to learn about our warranty policy and find an official after-sale support center in your country: https://www.aspirecig.com/service/
If your region does not have a support center, you can contact Aspire for service as normal.
Important Information:
When requesting warranty claims, kindly provide receipts of purchase from the vendor. Please also keep the original box containing the serial number, security code, or batch code for verification.
For detailed operating instructions, please visit:
Shenzhen Eigate Technology Co., Ltd.
Floor 1-4, Building 3, 4 Jianan Road, Shajing Sub-district, Bao'an District, Shenzhen, Guangdong Province, China
Tel: +86-755-81499783
Email: service@aspirecig.com
To learn more about our products and how to use them, please visit: www.aspirecig.com
Manufactured by Eigate
MADE IN CHINA
CE Ⓚ