Frymaster FilterQuick™ FS easyTouch® Quick Start

Initial Setup and Operation

Follow these steps for the initial setup and operation of your Frymaster FilterQuick™ FS easyTouch fryer:

1. Fill vats with oil to the lower fill line.
2. Turn on power switches (electric only) if applicable.
3. Turn controllers on by pressing and holding the power button for three (3) seconds.
4. The controller (A) will display “CHANGE FILTER PAD? YES/NO”.
5. Press YES, and the controller will display “REMOVE PAN”.
6. Remove the filter pan (C), and the controller will display “CHANGE FILTER PAD”.
7. Change the filter and reassemble the filter pan, ensuring the pan is out for 30 seconds. Re-install the filter pan.
8. Position the oil container in the right cabinet, placing the pick-up tube in the open container (E).
9. Press and hold the top off reset switch (D) until the oil level indicator (JIB) is full or the “Top Off Empty” display goes out on the controller.
10. A “P” indicates the filter pan is not properly placed. Reseat the filter pan if necessary until the “P” is no longer visible.
11. Respond YES to the “Filter Now” prompt by pressing the ✓ (YES) button.
12. Respond to the “empty oil container” notification by replacing the oil container (E) and resetting the top off reset switch (D), or by refilling the oil container with a bulk oil system.
13. If necessary to reboot the fryer system, press and hold the Reset Switch (G).

Component Identification:

• A: FQ4000 FS: Programmable for automatic filtering. Press the YES button to respond YES to the filter prompt.
• B: Power Switch: Located one in each fryer cabinet (electric only).
• C: Filter Pan: The pan used for filtering oil.
• D: Top Off Reset Button: Press and hold after replacing the oil until the “Top Off Empty” notice is no longer displayed.
• E: Oil Container: Holds oil for the automatic/manual top-off system. It is not used to fill the vats, only to maintain the oil level. Use only fresh oil in the top-off system.
• F: Pre-Screen Filter: A filter to catch larger food particles.
• G: Reset Power Switch: Located one in each cabinet under the USB port.

Note: The Frymaster FilterQuick™ FS-T fryer requires a start-up demonstration and training before normal restaurant operations can begin.

Daily Filter Pan Cleaning and Preparation

The filter paper in a FilterQuick™ fryer must be replaced at least once daily. In high-volume stores, it should be replaced more often. Use Frymaster PN 8030445 16.5”x25.5" filter paper and PN 8030002 for filter powder.

Replace O-rings every 90 days. ⚙️

The filter pan must be cleaned daily, and the filter paper replaced. Follow these instructions to prepare the filter pan:

1. Remove and disassemble the pan.
2. Discard old filter paper. Clean thoroughly. Do NOT leave any water in the pan. ❌

Reassemble the pan in this order:

1. Position the inner screen.
2. Place the filter paper on the pan.
3. Position the hold-down ring on the filter paper and lower into the pan.
4. Ensure the paper is folded up around the hold-down ring.
5. Position the crumb tray.
6. Firmly seat the filter pan in the fryer. Ensure the controller does NOT display P. ✔️