Graco SmartSense™ Soothing Bassinet

1 WARNINGS

Failure to follow these warnings and the instructions could result in serious injury or death.

• PLEASE SAVE OWNER'S MANUAL FOR FUTURE USE.
• DO NOT use product if it is damaged or broken.
• THIS PRODUCT REQUIRES ADULT ASSEMBLY. Follow assembly instructions carefully. If you experience any difficulties, please contact the Customer Service Department 1-800-345-4109.

SUFFOCATION HAZARD

Infants have suffocated:

• In gaps between a wrong-sized mattress or extra padding and side of the bassinet, and
• On soft bedding, pillows and extra bedding.

Use ONLY mattress pad provided by Graco.

• NEVER add a pillow, comforter or another mattress for padding.
• ALWAYS use mattress pad provided by Graco.
• Product can roll over on soft surfaces and suffocate child. Never place product on beds, sofas, cushions, or other soft surfaces.
• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by your physician.

• ALWAYS place child in the center of bassinet.

FALL HAZARD

Infants have suffered head injuries falling from bassinets and swings.

• To help prevent falls, STOP using this product when the infant begins to push up on hands and knees, weighs over 20 lb (9 kg) (approximately 5 months of age), or child's head and feet simultaneously touch head and foot ends of bassinet mesh sides, whichever comes first.
• The product must be fully assembled and installed, including 4 legs, 4 screws, 2 top rails, 2 side mounts, and mattress pad, before using. Always follow the instructions in the owner's manual to set up the product.
• ALWAYS provide the supervision necessary for the continued safety of your child. When used for swinging, never leave child unattended.
• NEVER lift or move product with infant in it.
• NEVER use product on slick surfaces.

STRANGULATION HAZARD

• Strings can cause strangulation! Do not place items with a string around a child's neck such as hood strings or pacifier cords. Do not suspend strings over a bassinet or cradle or attach strings to toys.
• DO NOT place product near water and moisture. Do not use the product near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub, swimming pool, wet basement, etc.
• DO NOT use the AC adapter if it has been exposed to liquids, has been dropped, or is damaged.
• Protect the power cord. Place it so it is not walked on or pinched by furniture or other items.
• DO NOT use with an extension cord.
• Use only 5V power cord provided.
• If a sheet is used with the mattress pad, use only the one provided by Graco that is specifically designed to fit the dimensions of the mattress pad.
• To help prevent heat build-up inside the bassinet and to avoid overheating your child, NEVER use an outdoor canopy.
• ALWAYS keep objects out of child's reach.
• DO NOT use product as a car bed.
• NEVER allow child under the product.

FCC/IC Compliance

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. CAN ICES-3 (B) /NMB-3 (B).

2 Features & Parts List

This model may not include some features shown below. Check that you have all the parts for this model BEFORE assembling your product. If any parts are missing, call Customer Service.

Tools required (not included): Phillips Screwdriver

Parts Diagram

Visual representation of parts:

• A: Base Leg (with plugs)
• B: Bassinet with Mattress Pad and 2 Top Rails
• C: Base Leg
• D: Bassinet Side Mounts
• E: Wall Plug (5.0V, 2.0A)
• F: Screws
• G: Mattress Sheet

Note: The red bag contains hardware; do not discard.

3 Assembly

3-A To Assemble Base

Parts Required/Piezas requeridas: Base Feet (A), Screws (F)

Tools required: Phillips Screwdriver

1. Place product (B) with bassinet down as shown.
2. Choose base leg with (A) sticker. Attach leg (A) to the mount on the bassinet with the (A) plug sticker, opposite the control panel. Fasten leg with screw.
3. Plug wire from leg (A) into plug opening in base.
4. Attach remaining 3 base legs (C) to remaining mounts, and fasten each with screw. Check legs are assembled by pulling out on them.
5. Stand bassinet up.

3-B To Assemble Bassinet

Parts Required/Piezas requeridas: Bassinet Side Mounts (D)

1. Remove mattress pad from bassinet.
2. Pull up the bassinet fabric and open fabric flaps covering the 2 openings in ends of bassinet.
3. Insert plastic side mounts (D) with snap fingers facing inward, into top fabric openings of bassinet. Route the snap fingers out the bottom fabric opening, and snap into base. Check side mounts are attached by pulling on them. NOTE: side mounts can be used in either end of the bassinet.