LIGHT IT! MultiFlex Floor Magnifier

Assembly Instructions

Follow these steps to assemble your MultiFlex Floor Magnifier:

1. Remove protective washers from the poles.
2. Screw the lower (long) pole clockwise into the base until secure.
3. Slide the wire through the threaded metal pole connector and hand tighten.
4. Thread the power cord through the upper (short) pole and insert the flexible arm.
5. Position the head assembly onto the base pole, inserting excess power cord.
6. Connect the power cables.
7. Securely attach the upper pole by rotating it clockwise.
8. Align the magnifier head and screw the threaded joint back into the upper metal pole until tightened.

Note: Perform assembly on a carpeted or padded surface to avoid damage.

Operation & Features

Inserting Batteries

The magnifier can operate using D Cell batteries (not included).

Using the AC Adapter

Alternatively, plug in the supplied 110V AC adapter for power. The lamp is now ready to use.

Power & Dimmer

• Press the power button to turn the lamp on/off.
• Press and hold the power button to activate the smart dimmer. The light will flash once at the highest and lowest settings. Release at the desired illumination level.
• The smart dimmer remembers the last set light level.

Specifications

Lamp: COB LED x 2 (6000K)

Lumens (battery/adapter): 200-20 LM / 500-50 LM

Smart Dimmer: Variable memory setting

Battery Type: D Cell x3 (not included)

AC Adapter Input: AC100-240 V, 50-60 HZ

AC Adapter Output: 5V DC, 2A

Lens Material: Acrylic

Magnification: Lens X2.5, Inset X6

Lens Dimensions: 6" x 4"

Magnifier Dimensions: 11" x 9" x 53"

Magnifier Weight: 8.5 lb

Care & Maintenance

• Clean with a soft, dry microfiber cloth.
• Use an approved acrylic eyeglass cleaner if necessary.
• Do not expose the lens to direct sunlight (fire hazard).
• Do not look directly into the light.
• For indoor use only.
• Do not mix battery types or use old batteries with new ones.

Note: Harsh chemicals or dirty cloths may scratch the lens.