Installation Steps

Follow these detailed steps to install your smart ceiling light fixture.

1. Unpack Components: Open the box and carefully take out all the parts.
2. Prepare for Assembly: Get every part unpacked and ready to start the assembly process.
3. Attach Short Tubes: Assemble the short tubes to the petals. The short end of each tube should be inserted into the petal.
4. Attach Long Tubes: Assemble the long tubes to the remaining petals. The short end of these tubes will twist into the petal.
5. Connect Petals to Plate: Assemble the petals with long tubes to the main mounting plate.
6. Secure Petals: Fix the assembled petals to the plate using the provided nuts.
7. Attach Remaining Petals: Assemble the remaining three petals with short tubes to the plate, as shown in the diagrams.
8. Corner Petal Attachment: Assemble a petal with short tubes to the corner of the plate.
9. Fasten Petal: Secure this petal with nuts.
10. Tighten Nuts: Use a [wrench] to further tighten all the nuts for a secure fit.
11. Wire Connections: Connect all the necessary wires to the collector plate.
12. Prepare Cross Bracket: Install screws with flat heads into the cross bracket. Use the small nuts to precisely settle the position of each screw.
13. Align Bracket: Place the cross bracket down. Find the four small holes on the main light plate and ensure all the screws installed on the cross bracket can go through these holes.
14. Mount Bracket to Ceiling: Install the cross bracket to the ceiling using the sharp point screws. Ensure the four flat-headed screws remain in place.
15. Mount Light Fixture: Lift the light fixture and install it onto the cross bracket. The four flat-headed screws should pass through the plate. Use the nuts to fasten the light securely.

Connecting the Remote Control

Follow these steps to pair the remote control with your new smart lights.

1. Insert Battery: Put battery [Battery] inside the remote control. Make sure it's workable.
2. Power On Light: Turn on the light using the wall switch [Light Switch].
3. Pair Remote: Press the "ON 1" button on the remote control within 3 seconds after turning the light on.

Connecting the App

Follow these steps to connect your smart lights to the mobile application.

1. Download App: Download the app by scanning the [QR Code] and install it on your phone.
2. Power On Light: Turn on the light using the wall switch [Light Switch].
3. Pair App: Open the app, enable Bluetooth on your phone, and click the button to search for the light. Follow the on-screen instructions to finish the pairing between your phone and the light.