Bike Wheel LED Lights

Please read the entire instruction manual before using the product and then save it for future reference. We reserve the right for any errors in text or images and any necessary changes made to technical data.

Mounting

To mount the light:

Use the provided shim to fix the light onto 1.8mm & 2mm spokes. For 2.3mm spokes, attach the light directly.

The diagram shows a hand holding a light unit and attaching it to a bicycle wheel spoke. An inset circle shows a close-up of the attachment mechanism, illustrating the use of a small shim to fit spokes of 1.8mm or 2mm diameter, or direct attachment to a 2.3mm spoke. An arrow indicates the direction of attachment. Attach the light to the spoke.

Safety

• Do not point the light beam into anyone's eyes.
• Do not let children play with the product.
• Never subject the product to high temperatures or naked flames.

WARNING: INSERT BATTERIES IN THE CORRECT POLARITY AND ALWAYS FOLLOW THE MANUFACTURER'S INSTRUCTIONS. DO NOT MIX NEW AND USED BATTERIES, ALKALINE. STANDARD (CARBON-ZINC), OR RECHARGEABLE (NICKEL-CADMUM) BATTERIES. REMOVE BATTERIES IF PRODUCT WILL BE STORED FOR AN EXTENDED PERIOD. DISPOSE OF USED BATTERIES RESPONSIBLY.

WARNING: THIS PRODUCES FLASHES THAT MAY TRIGGER EPILEPSY IN SENSITISED INDIVIDUALS. ⚠️

Switching on/off

On - Works when vibrating.

Off - Enters standby mode after 25 seconds.

Instructions for use batteries

Required: 3 x 1.5V AAA batteries (not included).

To install batteries:

The diagram shows three cylindrical batteries labeled "AAA" and a representation of the battery compartment within the light unit, indicating the positive (+) and negative (-) terminals. It visually depicts inserting the batteries correctly.

• Unscrew the silver cap.
• Insert 3xAAA batteries, following the polarity markings in the battery compartment to ensure correct orientation.
• Never mix old and new batteries. Never mix rechargeable and non-rechargeable batteries.
• Reassemble the silver cap.

Care and maintenance

• Clean the product by wiping it with a damp cloth. Use only mild cleaning agents; never use solvents or corrosive chemicals.
• Remove the batteries if the lights are not to be used for a long time.