ONBRICK General Guide

PLEASE NOTE:

All acrylic panels have protective film applied on both sides. Please remove before assembly.

[Image: A hand peeling protective film from an acrylic panel.]

All side panels have a top and bottom orientation. The deeper cutouts go at the bottom.

• Connect the four clear side panels using the connectors, ensuring the deeper cutouts face downward toward the base. Additional connections may be required for extra stability depending on the height.
• Insert the stands or LEGO studs into the base panel, if applicable.
• Position the assembled side panels around the base, then close the case by placing the lid on top.
• Always hold the base when moving the display case.

[Image: Diagram showing the assembly of acrylic panels with labels: Top (Clear), Front/Back (Clear), Base (Black), Left/Right (Clear), indicating screw placement.]

SPECIAL PARTS

ONBRICK

• 4mm+6mm Base with Special connectors

  [Image: Diagram showing a base with special connectors.]

• Tier Case with shelf

  [Image: Diagram illustrating a tiered case with a shelf, showing upper and lower black base panels (4mm and 6mm respectively) with screw connections.]