Boston 1 Coffee Table Assembly Instructions

Assembly Information

This document provides assembly instructions for the Boston 1 coffee table. Please follow these steps carefully to ensure correct assembly.

Contact Information: M2 Kollektion GmbH | In den Schafwiesen 26 | 71720 Oberstenfeld | Email: info@m2-kollektion.de

Parts List

Please verify all parts are present before beginning assembly:

• 1x Glass Top (①)
• 1x Table Frame (②)
• 3x Legs (③)
• 4x Support Brackets (④)

Hardware:

• A: Screws (x6)
• B: Screws (x12)
• C: Screw (x1)
• D: Screws (x3)
• E: Screws (x6)

Assembly Steps

Step A: Attaching the Frame to the Table Top

Place the glass top on a soft, clean surface to prevent scratching. Align the table frame with the pre-drilled holes on the underside of the glass top. Secure the frame using screws (A and E) and screws (B). Important: Screw parts A and E in by hand. Do not use a cordless drill.

Visual Aid: Two diagrams show the correct and incorrect methods for placing the glass top. The correct method shows the glass top on a rug with a checkmark. The incorrect method shows the glass top directly on a hard surface with a cross mark.

Step B: Securing the Legs

Attach the legs (③) to the frame using screws (B). Ensure all legs are securely fastened. Then, attach the support brackets (④) to the legs and frame using screws (D).

Visual Aid: An exploded view diagram shows the assembly of the table frame, legs, and support brackets, with labels indicating the parts and hardware required for each step.

Step C: Final Check

Ensure all screws are tightened. The table is now ready for use.

Visual Aid: A diagram shows the fully assembled table. Three warning symbols are displayed: a person sitting on the table with a cross mark, a person standing on the table with a cross mark, and a person pushing the table with a cross mark.

Service and Support

For service, assistance, or inquiries, please refer to the contact information provided.