Feit Electric RGBW Speaker Bulb BTOM60RGB3KESM

Single Bulb Pairing Instructions

1. Power on the bulb. The bulb will sound a chime when available to pair.
2. Using a compatible Bluetooth device, search for the bulb "RGBW Speaker Bulb".
3. Connect, wait for the chime that signifies successful pairing, and play music.

Two Bulb Pairing Instructions (TWS)

1. Power on two bulbs at the same time. Both bulbs will sound a chime when available to pair.
2. Wait until the bulbs automatically connect to each other. One will become the primary and the other will become the secondary. The secondary bulb will sound a chime once complete, indicating that it is successfully connected to the primary bulb.
3. Using a compatible Bluetooth device, search for the primary bulb "RGBW Speaker Bulb".
4. Connect to the primary bulb, wait for the chime that signifies successful pairing, and play music.

Remote Operation

The remote control allows for the following operations:

1. Audio On/Off: Turns the audio On or Off.
2. Light On/Off: Turns the light On or Off.
3. White Light Dimmer: Press to choose between brightness levels of white light.
4. Color Light Cycling: Press to continuously cycle through all six colors: Red, Green, Blue, Magenta, Cyan, Yellow.
5. Color Light Solid: Press to select one of the six color options.

Resetting Bulb to Color Light Cycling: If the remote is lost or not working properly, reset the bulb to color light cycling by flipping the wall switch three times.

CAUTION

⚠️ This device is not intended for use with emergency exits. Only use the control provided with or specified by these instructions to control this lamp. This lamp will not operate properly when connected to a standard dimmer or dimming control.

Federal Communications Commission (FCC) Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement: For Light (Model No.:BTOM60RGB3KESM) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

FCC Radiation Exposure Statement: For remote control (BTOM60RGB3KESM/REM) This equipment complies with FCC radiation exposure requirement. The device can be used in portable exposure condition without RF restriction.