HOMMIE LED Mirror Light

Specifications

Installation Methods

Mounting on the Wall/Cabinet

Follow these steps for mounting the light fixture on a wall or cabinet:

1. Drill holes as required.
2. Insert expansion plugs into the drilled holes.
3. Mount the screw bracket/cabinet bracket and the LED mirror light to the wall/cabinet in order, and secure them with screws.

Diagram Description: The diagram shows a sequence of three steps: (1) drilling holes, (2) inserting expansion plugs into the holes, and (3) attaching a mounting bracket to a surface.

Mounting Above the Mirror

Follow these steps for mounting the light fixture directly above a mirror:

1. Install the screw bracket to the light fixture.
2. Insert the groove of the mirror light directly above the mirror.

Diagram Description: The diagram shows attaching a bracket (labeled '1') to the LED light fixture, and then sliding the fixture's groove onto the top edge of a mirror.

Electrical Wiring Installation Guide

1. Preparation

1. Power Off: Disconnect all relevant power sources before starting. [power off]
2. Inspect Wires: Check power and fixture wires for damage or wear.

2. Connecting the Socket

1. Open the junction box and loosen the fastening screws in the wiring hole.
2. Insert the power cord into the corresponding hole of the lamp cord and tighten the fastening screws.
3. Assemble the junction box and connect the plug to the socket.

Diagram Description: The diagrams illustrate the process of opening a junction box, connecting wires (live, neutral, earth) to terminals, and connecting the power cord to a 230V socket.

3. Connecting the Wall Switch

1. Open the junction box and loosen the terminal screws.
2. Connect the live wire of the wall switch to the terminal hole, then tighten the screws securely.
3. After reassembling the junction box, the mirror light can be controlled via the wall switch.

Diagram Description: Similar to connecting the socket, these diagrams show opening the junction box, connecting the live wire from a wall switch to the terminals, and reassembling.

4. Safety Check

1. Ensure all connections are tight.
2. Wrap exposed wires with electrical tape to prevent short circuits or electrical leakage.

5. Power On

Restore power only after confirming all connections are secure and insulated.

Manufacturer Information

Manufacturer: ZHONGSHAN MUGU LIGHTING CO., Ltd.

Address: 6th Floor, No. 22, South 5th Street, Cao an South Road, Jun dusha Industrial Zone, Cao Er, Guzhen Town, Zhongshan, Guangdong, China.

Certifications: FC, CE, RoHS, UKCA.

Made in China.