BANKAMP 7799/1-xx LED Ceiling Light

Electrical Installation

Note: According to VDE regulation 0100, this installation must be carried out by an authorized and qualified technician.

Safety Class I: This light has a protective conductor. The protective conductor must be connected to the terminal marked with this symbol [ground symbol].

Wiring Diagram:

The diagram shows a connection block with terminals labeled L, N, and a ground symbol. Wires are shown being inserted into these terminals.

Ceiling Mounting

The following steps describe the ceiling mounting process:

1. Step 1: Mark the mounting points on the ceiling using a pencil.
2. Step 2: Drill holes for the mounting screws. The diagram indicates a 3mm drill bit and shows screws being inserted with wall plugs.
3. Step 3: Secure the mounting bracket to the ceiling.
4. Step 4: Attach the light fixture to the mounting bracket. The diagram shows arrows indicating the fixture being pushed upwards and secured magnetically.

The light fixture is described as having 'no dot technologie' and 'CRI >90'. It also indicates 'magnetic' attachment.

Product Information

This product contains light sources of energy efficiency class G.

Safety Instructions

• Electrical connections must only be performed by qualified electricians.
• Warning! Before starting assembly, switch off the main power supply, turn the switch to OFF, and remove or switch off fuses.
• Ensure that installation cables are not damaged by fastening screws.
• Interrupt the power supply before changing the light source. Light sources can reach temperatures over 350°C; allow them to cool before replacement.
• When replacing light sources, ensure that the maximum power (W) and voltage (V) ratings match those of the fixture.
• Do not touch halogen lamps with bare hands. If touched, clean the lamp with a soft cloth to remove residue.
• Protect the light from moisture during operation.
• The manufacturer is not liable for damages resulting from improper use.
• Parts of the light can become very hot during operation; avoid direct contact to prevent burns.

Symbol Explanation

• Protection Class 1: This light has a protective conductor that must be connected to the terminal marked with the ground symbol.
• Protection Class 2: This light is double insulated and does not have a protective conductor connection.
• This light is suitable for mounting on normally flammable surfaces.
• This symbol indicates the minimum distance between the reflector and the illuminated surface.
• Low-pressure symbol: When using low-pressure lighting media, only low-pressure replacement lighting media marked with this symbol may be used.