BANKAMP Strada-LED Lighting System
Assembly and User Instructions
Product Identification
Model Numbers: 2143/155, 2143/185
Brand: BANKAMP
Product Type: LED Lighting System
General Safety Information
Warning: Electrical connections must be performed by qualified electricians only. Ensure the power supply is disconnected before commencing any assembly or maintenance work. Bring the switch to the OFF position and remove or disconnect fuses. Take care to prevent fastening screws from damaging internal wiring. Allow the lighting element to cool before replacement. Ensure replacement lighting elements match the specified maximum wattage and voltage. Avoid touching halogen bulbs with bare hands; if touched, clean with a soft cloth. Protect the fixture from moisture during operation. The manufacturer is not liable for damages resulting from improper use. Some parts of the fixture may become very hot during operation; avoid skin contact to prevent burns.
Symbol Explanations:
- Protection Class I: Requires connection to a protective conductor (ground).
- Protection Class II: Double insulated, no protective conductor connection required.
- Flammable Surfaces: Suitable for mounting on normally flammable surfaces.
- Minimum Distance: Indicates the minimum distance between the reflector and the illuminated surface.
- Low-Pressure Lamps: When using low-pressure lamps, only use compatible low-pressure replacement lamps.
Installation Instructions
Ceiling Mounting:
- Preparation: Use the provided drilling template for the light rail. Drill holes of 6mm diameter.
- Mounting: Secure the light rail to the ceiling. Ensure it is level.
- Electrical Connection: Connect the 230V power supply.
- Grounding: The protective earth (PE) conductor must be connected for proper dimmer function.
LED Pendant Mounting:
- Attach the LED pendant to the rail.
- Connect the LED driver unit.
- Connect the LED control unit.
LED Driver Unit Replacement: Ensure the LED rail is disconnected from the power supply before replacing the LED driver unit.
LED Control Unit Replacement: Ensure the LED rail is disconnected from the power supply before replacing the LED control unit.
Smart Home Integration (ZigBee)
The Strada-LED system features innovative vertical dimm and warm dimming technology and is equipped with a ZigBee wireless standard for smart home integration. The unit is set to factory defaults.
To integrate the light into an existing SMART Home network:
- Mount and connect the luminaire to the power supply.
- Turn the light on and off using the light switch repeatedly (at least 5 times consecutively: 1 second ON, minimum 3 seconds OFF).
- The luminaire will flash 3 times to indicate it has been successfully decoupled.
- The luminaire can now be integrated into your SMART Home network.
ZigBee Standard: ZigBee is a widely used standard in home automation, sensor networks, and lighting technology due to its ease of use, flexibility, and energy efficiency. BANKAMP utilizes ZigBee for controlling its new product line.
Information on ZigBee Integration:
- Link to Philips HUE: https://youtu.be/yjiBJ5d01vY
- Link to Philips HUE: https://youtu.be/4YZgBh_YHOU
System Calibration
Upon initial startup or after a pendant change, an automatic system calibration occurs, lasting approximately 30 seconds. During this calibration period, the system cannot be operated. Ensure the LED rail is disconnected from the power supply before any pendant changes or LED driver/control unit replacements.
Product Information
This product contains a light source of energy efficiency class F.
Estimated Lifespan: 25,000 hours
Further Information
For more information, visit: www.bankamp.de
