TKH Security - Home
User Guide for TKH SECURITY models including: BL2026M 6MP IP Bullet Camera, BL2026M, 6MP IP Bullet Camera, Bullet Camera, Camera
» BL2026M
BL2026M – Catalog | TKH Security
File Info : application/pdf, 2 Pages, 502.66KB
DocumentDocumentBL2026M 6MP IP Bullet camera, 5x motor zoom Quick Start Guide Unpack Camera Unit Mounting Adapter Quick Start Guide CAT-6 RJ45 conduit & Pin pusher Screws(4x) & Plastic Screw Anchors (4x) Security Torx Subject to modification. Actual product and accessories may differ in appearance. Connector Definition No. Connector 1 Alarm I/O Definition Alarm I/O connection 2 Audio I/O Line In and Line Out connection 3 RJ-45 Port For network and PoE connections. Please contact Siqura for a compatible PoE injecter. 4 Power(DC 12V) Power Connection Insert the SD card into the card slot to store 5 Micro SD Card Slot videos and snapshots. Do not remove the SD card when the camera is powered on. 6 Reset Button To restore camera to factory defaults, power up with Reset button pressed for at least 10s. Table 1 Connector definition © TKH Security B.V. 2024 | Version 2 (20241209) | BL2026M-QS-EN Find additional manuals, the datasheet, the EU Declaration of Conformity, and the latest firmware for this product at: tkhsecurity.com Installation Notices Caution installation shall be performed by qualified personnel only. Installation shall be in accordance with local procedures. The camera contains batteries. Battery replacement shall not be applied in view of the risk of explosion. Dispose of used batteries according to the instructions. For "PoE" input connection, use only with UL listed I.T.E. with "PoE" output. Description for the "PoE" is intended to be connected to not exposed (outside plant) networks or equivalent statement in installation instructions. Manufacturer information: Name: TKH Security B.V. Address: Werner von Siemensstraat 7, 2712PN, Netherlands Email: info.nl@tkhsecurity.com Connectors 56 1 2 3 4 Camera Cabling Figure 1 Camera Connectors Waterproof Notice Bullet camera is suggested to be mounted either by wall/pole mount or ceiling mount. Other mounting may cause potential water leakage at camera, which is not covered in warranty. Figure 2 Cabling Figure 3 Wall/Pole Mount Figure 4 Ceiling Mount Accessing the Camera - DHCP DHCP Accessing the camera Fixed IP 30s IP = 10.x.y.z Network Switch IP = 10.x.y.z IP = 192.168.1.x Network Switch IP = 192.168.1.x Auto detect with SDM2 1 SDM2-vx.xx-setup.zip Tkhsecurity.com Enter to the camera product page. 2 3 DHCP 1st time camera login Set a strong password DHCP 1st time camera login Look for SDM2 Browser-based Viewer x6W@oM0a!9#F qwer1234 x6W@oM0a!9#F © TKH Security B.V. 2024 | Version 2 (20241209) | BL2026M-QS-EN It is not recommended to continuously (24/7) record with the micro-SD card, as the camera may not support long-term continuous data read/write. Contact the manufacturer of the micro-SD card for information regarding the reliability and the life expectancy.