Kitchen Faucet Installation Manual

Content Overview

This document provides installation instructions for the Kitchen Faucet, model W-80(ES). It includes a parts list, step-by-step installation procedures, and warranty information. The manual is available in both English and Spanish.

Prior to Installation

Before beginning the installation process, please follow these important steps:

1. Ensure all necessary parts are available by referring to the diagram and parts list.
2. Verify that your sink is compatible with the kitchen faucet size.
3. Do not disassemble the main faucet body, as it has been properly installed and tested before delivery from the factory.
4. Turn off the hot and cold water supply before starting the installation.
5. To prevent the faucet from clogging, flush the water pipes before installation.
6. After completing the installation, check all joints and connections for leaks.

Diagram showing hot and cold water connections.

Diagram illustrating a pipe connection.

Diagram showing a crossed-out leak symbol, indicating to check for leaks.

Standard Part List

The following parts are included with your faucet:

Diagram showing the faucet assembly with numbered parts: 1. Faucet body, 2. Cold and hot water inlet pipes, 3. Tailpiece nut assembly, 4. Instruction manual, 5. G9/16 to NPT1/2 adapter.

Installation Steps

Follow these steps carefully for proper installation:

1. Remove the tailpiece nut assembly from the threaded pipe. The countertop cutout dimensions are as shown in the diagram.

   Diagram showing screwing the inlet pipe into the faucet body with a wrench.

2. Insert the faucet body into the hole on the countertop. Secure the tailpiece nut assembly onto the threaded pipe connection under the sink in the correct order and tighten using a screwdriver.

   Diagram showing inserting the faucet body into the countertop hole and securing the tailpiece nut assembly.

3. Adjust the direction of the faucet body.

   Diagram showing adjusting the direction of the faucet body.

4. Connect the hot and cold inlet hoses to the angle stops. Tighten with a wrench until snug. Turn on the hot and cold angle stops and check for leaks.

   Diagram showing connecting inlet hoses to angle stops and checking for leaks.

Warranty Information

Warranty Duration

All components of this faucet system are covered under a lifetime limited warranty, ensuring they are free from defects in material and workmanship for the original purchaser.

Repair and Replacement

If the product shows defects in material or workmanship under normal use and within the warranty period, the manufacturer will, at its discretion, either repair the product or provide a replacement at no cost to the original purchaser. Proof of purchase (e.g., an invoice) is required when requesting service. The warranty does not cover damages caused by improper installation, misuse, or modifications.

Exclusions

The manufacturer shall not be responsible for the following cases:

• Damage to the product caused by improper installation, misuse, unauthorized repair or replacement, or abuse (including damage during shipment).
• Damage to the product caused by improper dismantling after installation.
• Damage resulting from abnormal water pressure or impurities in water pipes, which is not covered under this warranty.
• Rust on the product due to insufficient care and maintenance, which is not covered under this warranty.
• Damage caused by natural disasters such as fire, flood, earthquake, lightning storms, etc., which is not covered under this warranty.