Q Smart Home Lights
Fitting Instructions | Montageanleitung
Product Information
Model Number: 832505
Technical Specifications:
| Feature | Specification |
|---|---|
| Power Input | 230V/50Hz~ |
| LED Board | 1x LED-Board 24V DC / 56W (not changeable) |
| Wireless Frequency | 2.4 GHz |
| Transmit Power | 10 dBm |
| LED Power Consumption | 56 W |
| LED Luminous Flux | 6.160 lm |
| Total Power Consumption | 60 W |
| Total Luminous Flux | 3.900 lm |
| LED Board Lifespan | 25.000 h |
| Color Temperature | 2.700 - 5.000 K |
| Switching Cycles | 15.000 x |
| Response Time | <0,5 s |
| Dimming | Dimmable with RRC (Radio Remote Control) |
Included Accessories:
- Radio remote control
- 2x AAA 1.5V Batteries
Certifications: CE
Assembly / Fitting
Step 1: Montage / fitting as floor light
The diagram shows the floor light pole being attached to its base. A power adapter (labeled '1') is connected to the light pole (labeled 'X') and the base (labeled 'Z').
Step 2: Electrical connection
The diagram illustrates connecting the light to a 230 Volt / 50 Hz power outlet. The power adapter connects to the light and then plugs into a standard wall socket (labeled '2').
Step 3: Teach remote control
Refer to the Q-remote control manual for detailed instructions. The process involves:
- Switch on the lamp.
- Read the instruction manual for the remote control.
- Teach the Q-remote control to the Q-receiver (antenna) by following the specific pairing procedure, which may involve pressing buttons on the remote and the receiver. The diagram shows the remote control (labeled '5') communicating wirelessly with the Q-receiver.
Resetting the Lamp
To reset the lamp to factory settings, cycle the power on and off five times. The sequence is approximately:
- On (5-10 sec)
- Off (1-2 sec)
- On (1-2 sec)
- Off (1-2 sec)
- On (1-2 sec)
- Off (1-2 sec)
- On (1-2 sec)
Declaration of Conformity
This device complies with the fundamental requirements of Directive 2014/53/EU (Radio Equipment Directive) of the European Parliament and of the Council of the European Union dated 16.04.2014 concerning radio equipment.
The full declaration of conformity can be accessed at:
