Teamtex Type F9 Group 2-3 Car Seat

User Manual and Safety Instructions

Introduction

Thank you for purchasing a Teamtex Group 2-3 car seat. For assistance, please contact customer service.

Safety Instructions

WARNING: Read these instructions carefully before use and keep for future reference. Failure to comply may compromise your child's safety.

Install only on a forward-facing seat with a 3-point seat belt (1).
Ensure hard and plastic parts are not trapped under movable seats or in vehicle doors.
Keep all straps tight and untwisted.
Ensure sub-abdominal straps are low to keep the pelvis in position.
Replace the system if subjected to violent shocks in an accident.
Do not modify the system without authorization or deviate from manufacturer instructions.
Protect the seat from direct sunlight to prevent burns.
Never leave a child unattended in the restraint system.
Secure luggage and other items to prevent injury in case of impact.
Do not use the system without its cover.
Use only manufacturer-recommended covers.
Contact the manufacturer with any installation or usage questions.
Install on seats categorized as "Universal" in your vehicle manual.
Use only specified weight-bearing contact points.
Always prefer rear seats.
Always ensure the vehicle seat belt is fastened.
Avoid bulky winter clothing for the child.

Your Group 2-3 Booster Seat (2)

The seat is designed for Group 2-3, accommodating children from 15 to 36 kg (approximately 3 to 12 years).

Key Components:

1. Height adjustable head support
2. Diagonal belt guide (x2)
3. Back
4. Seat

Assembly and Installation

Assembly:

The booster seat consists of a seat base and a backrest. To assemble, connect the backrest to the seat base as shown in diagrams (3-6).

In-car Installation:

Ensure the adjustable head support is set to your child's size before installation.

Important: Never remove the back support, as it is essential for lateral protection.

Head Support Adjustment:

The adjustable head support is designed to grow with your child, providing maximum lateral protection. Position the belt guides as close to your child's shoulders as possible (7, 8).

Installation Steps:

Place the car seat against the vehicle's back seat (9).
Seat your child in the car seat.
Route the vehicle's 3-point seat belt: The diagonal belt goes through the head support's belt guide and under the opposite armrest. The lap belt goes under both armrests (10).
Fasten the vehicle seat belt.
Ensure the seat belt is tight and not twisted.

Optional Cup Holder

Slide the cup holder into the guides on either side of the seat (11). WARNING: Do not place heavy objects in the cup holder that could become projectiles during an impact.

Manual Storage

A dedicated compartment is available for storing the instruction manual (12).

Maintenance Advice

All fabric parts are removable.
For light stains, clean with a damp sponge and soapy water, or hand wash at 30°C.
Do not use bleach, iron, machine wash, or tumble dry.

Homologation and Compatibility

This car seat is a "Universal" child restraint system, approved according to regulation N°44/04. It is suitable for general use and compatible with most vehicle seats.

For optimal compatibility, check if your vehicle manufacturer states suitability for "Universal" child restraint systems. This system meets the strictest "Universal" approval criteria.

It is only suitable for vehicles equipped with 3-point safety belts approved according to UN/ECE N° 16 or equivalent standards.

If in doubt, contact the manufacturer or retailer.