Basic Temp (DT-01B) Digital Thermometer User Manual

This document provides instructions for the safe and effective use of the Celimed Basic Temp (DT-01B) digital thermometer.

Safety Instructions

Read all safety instructions before use. ⚠️

  • Never bite, bend, drop, or disassemble the thermometer.
  • Keep the product out of children's reach. ?
  • Do not expose to direct sunlight, high temperatures, moisture, or dirt.
  • Do not attempt to disassemble the unit, except for replacing the battery.
  • In case of persistent high temperature, especially for children, contact your doctor.
  • The thermometer contains small parts (battery, battery cover) that can be swallowed by children. Do not leave the thermometer unattended in the presence of children.
  • If the battery fluid comes into contact with skin or eyes, flush with water and seek medical assistance.
  • Choking hazard! Small children may swallow or choke on batteries. Keep batteries out of their reach.
  • Risk of explosion! Never throw batteries into fire. Do not charge or short-circuit batteries.

Product Overview and Intended Use

The Basic Temp (DT-01B) is a digital thermometer designed for measuring body temperature. It is suitable for clinical (healthcare) and home use, as well as for oral, axillary, and rectal measurements. Any use other than specified is considered improper use.

Operating Instructions

Follow these steps for accurate temperature measurement:

  1. Disinfect the probe with a cloth dampened with water or an alcohol-water solution before and after each use.
  2. Press the ON/OFF button. The display will show "188.8 °C" for about 3 seconds, followed by a flashing "L °C", indicating the thermometer is ready.
  3. During measurement, the temperature value will increase on the display.
  4. The thermometer will emit 4 beep sounds ? when the measurement is complete (temperature stabilized for 16 seconds).
  5. Switch off the unit by pressing the ON/OFF button to prolong battery life. The unit will automatically switch off after approximately 10 minutes of non-usage.

Measurement Methods:

  • Oral Usage: Keep mouth closed for at least 1 minute before measurement. Place the probe under the tongue, close mouth. Measurement duration: 50–70 seconds. Oral temperature is approximately 0.3–0.8 °C lower than rectal measurement.
  • Axillary Usage: Dry the skin under the armpit. Ensure the probe is in perfect contact with the skin. Measurement duration: 80–120 seconds. For more accurate results, extend measurement to approximately 5 minutes, despite the beep. Axillary temperature is approximately 0.5–1.5 °C lower than rectal measurement.
  • Rectal Usage: Insert the probe into the rectum approximately 2 cm deep. Measurement duration: 40–60 seconds. Rectal measurement is considered the most accurate as it reflects internal body temperature.

Record the temperature and time after each measurement. The last measured value is automatically stored in memory.

Memory Function

The last measured temperature is automatically stored. It can be viewed by switching the thermometer off and on again immediately after the "L °C" display. Subsequent measurements will overwrite the stored value.

Maintenance

Clean the thermometer before and after each use with a soft cloth dampened with water or an alcohol-water solution (70% ethanol or isopropyl). Store the thermometer in its plastic case. The thermometer is not waterproof; never immerse it in water or other liquids.

Battery Replacement

When the LCD displays the ? symbol in the bottom right corner, the battery needs replacement.

  1. Remove the colored end cap.
  2. Use a non-metal pointed object (e.g., a pen) to remove the old battery.
  3. Insert a new 1.5V LR41 battery, observing correct polarity (+/-).
  4. Replace the battery cover.

Notes on handling batteries:

  • Keep batteries out of children's reach.
  • If a battery leaks, wear protective gloves and clean the compartment with a dry cloth.
  • Protect batteries from heat.
  • Never throw batteries into fire.
  • Do not charge or short-circuit batteries.
  • Remove batteries if the device is not used for a long period.
  • Use only identical or equivalent battery types. Replace all batteries simultaneously. Do not use rechargeable batteries.
  • Do not attempt to open or mechanically damage batteries.

Symbols

  • [Follow instructions]
  • Type BF applied part
  • [Keep dry]
  • Battery produced according to European Directive 2006/66/CEE
  • Manufacturer
  • EU Representative
  • MD Medical Device

Disposal

This device, including its parts and accessories, must not be disposed of with municipal waste. Dispose of it separately according to European Directives at designated recycling centers for electrical and electronic equipment, or return it to the retailer when purchasing a new equivalent device. Batteries must be disposed of in special collection bins at the end of their life.

Warranty

This device is covered by a 2-year warranty from the date of purchase. The warranty does not cover defects caused by improper handling, batteries, packaging, or any further damage. Proof of purchase is required for warranty claims.

Technical Specifications

SpecificationDetails
ModelBasic Temp (DT-01B)
Product CategoryClinical Electronic Thermometers
Measuring Range32 °C ~ 42.0 °C
Display Resolution0.1 °C
Temperature DisplayShows "Lo °C" for < 32 °C, "Hi °C" for >= 42 °C
Accuracy±0.1 °C (35.5 °C–42.0 °C); ±0.2 °C (outside this range)
Measurement Completion Signal4 consecutive beeps ? (when temperature stabilizes for 16 seconds)
Display TypeLCD
Power Supply1 × 1.5V LR41 battery
Battery Service LifeApprox. 100 hours of continuous measurement
Operating ConditionsTemperature: +5 °C to +35 °C; Relative Humidity: ≤ 80%
Storage & Transport ConditionsTemperature: -25 °C to +55 °C; Relative Humidity: ≤ 95%
Product Dimensions125 × 18 × 8 mm
Product Weight12 g (including battery)
Expected Service LifeApprox. 5 years

Information on Electromagnetic Compatibility (EMC)

This medical device requires special care regarding electromagnetic compatibility. It must be installed and used in compliance with the accompanying documents. Portable and mobile radio communication devices may affect the thermometer's operation.

Manufacturer and Importer Information

Manufacturer: Hangzhou Hua'an Medical & Health Instruments Co., LTD, Building 2, 1 # Fuzhu Nan RD, Wuchang Town, Yuhang District, Hangzhou, Zhejiang 310023 China

EU Representative: Shanghai International Holding Corporation GmbH, Eiffestrasse 80, 20537 Hamburg, Germany

CZ Importer: Celimed s.r.o., Sociální péče 3487/5a, 400 11 Ústí nad Labem, Česká republika, www.celimed.cz

SK Distributor: Celimed s.r.o., Pri majeri 22, 831 06 Bratislava, www.celimed.sk

Models: DT-01B, Basic Temp DT-01B Digital Electric Thermometer, Basic Temp DT-01B, Digital Electric Thermometer, Electric Thermometer, Thermometer

File Info : application/pdf, 2 Pages, 1.39MB

PDF preview unavailable. Download the PDF instead.

manual-web-teplomer-celimed-basic-temp

References

Adobe InDesign CS5 (7.0.4) Adobe PDF Library 9.9

Related Documents

Preview Celimed Flex Temp Digital Thermometer - Product Information and Operating Guide
Comprehensive information on the Celimed Flex Temp digital thermometer, including product description, operating instructions, technical specifications, and safety warnings. Multilingual content summarized in English.
Preview Celimed Classic TC-01 Lekársky Teplomer Návod na Použitie
Podrobný návod na použitie lekárskeho teplomeru Celimed Classic TC-01, vrátane pokynov na použitie, bezpečnostných opatrení, metód merania a čistenia.