Avantree TWS116 True Wireless Earphones for TV
User Manual
Product Overview
Model No.: BTHS-TWS116 (Avantree TWS116)
What's in the box:
- Earphones (Left & Right)
- Charging Case
- USB-C Charging Cable
- Earhooks
How to wear:
Place the earhook part horizontally along the top edge of your ear (Fig. 1), then slide it back and downwards (Fig. 2) until the earhook is pointing down and the earpiece rests gently against your outer ear (Fig. 3).
Earphones LED status:
| Status | LED Indicator |
|---|---|
| Pairing mode | Either LED flashes BLUE and RED alternately |
| Connected | Both LEDs flash BLUE once every 8 seconds |
Battery indicator of charging case:
| Status | LED Indicator |
|---|---|
| Battery low | Steady BLUE |
| Charging | Steady RED |
| Fully charged | Turns off |
USB-C charging port
Basic Operations
Multifunction buttons:
- Play / pause: Click once on either side
- Volume up / down: Press & hold on the RIGHT / LEFT earphone
- Previous / next track: Click twice on the RIGHT / LEFT earphone
- Answer/end a call: Click once on either side
- Activate Siri / Google Assistant (Phone dependent): Click three times on either side
Connecting to a Phone / Tablet / TV
For first-time use, please put both earphones onto the charging case.
- Remove BOTH earphones to turn them ON.
- Wait for the LED on either earphone to flash BLUE & RED alternately to enter PAIRING MODE.
- Search & select Avantree TWS116 from the Bluetooth menu on your device to connect. If you are using a Bluetooth transmitter, please ensure your transmitter is also in PAIRING MODE (please refer to your user manual).
- Once connected, both earphone LEDs will flash once every 8 seconds.
Notes:
- If your TV is not Bluetooth enabled, you will need to buy a separate Bluetooth transmitter (Avantree recommends the Avantree Oasis (Plus) / Audikast).
- If you use your TV's optical audio output, you may need to set your TV audio format to PCM (or STEREO) and turn OFF DOLBY if present (please refer to your transmitter's user manual).
Using One Earphone
Either side can be used separately as a mono earphone.
- Make sure you have previously connected the earphones with your phone as a TWS pair first.
- For subsequent use, just remove either earphone from the case and it will auto-reconnect to your device.
Note: To connect with another device, please turn off Bluetooth on the previously connected device.
Reconnecting
The earphones will auto-reconnect to your last paired device the next time you remove them from the case. If not, please select Avantree TWS116 on your device to manually reconnect.
User Tips and Troubleshooting
No sound when used with a Bluetooth transmitter?
Check out this link for detailed instructions and other troubleshooting tips: https://avantree.com/product-support/BTHS-TWS116-BLK
- Make sure that the earphones and the transmitter are connected. You should hear “connected” from the earphones and the earphone LED indicators should flash once every 8 seconds.
- TV settings - Change the Digital sound format to PCM (or STEREO). If you see DOLBY in the TV Settings menu, turn it OFF.
