WIRELESS BINDING GUIDE
T3R Programmable Thermostat
On the Wireless Relay Box
- Press the ?️ pinhole button for 3 sec. The LED should flash ? once.
- Press and hold the ? button for 3 sec. The LED should blink ? continuously.
On the Programmable Thermostat
- Hold the Thermostat ~1m away from the Relay Box and press the ☰ MENU and ➖ buttons together for 3 sec to enter binding menu.
If 14A and 0 is flashing follow steps 4-8
If 14A and 1 is flashing follow steps 9-12
- Press the ✔️ button. 0 should start flashing ⚡.
- Press the ➕ button. 1 should start flashing ⚡. A small 1 will appear on left side. If a 0 appears repeat.
- Press the ✔️ button until SAVE is displayed. The LED on the Relay Box should change to ?.
- Press the ↩️ button to return to the Home Screen.
- Cycle the temperature all the way up and then all the way down to test that the Relay Box is switching on and off (this might take a few minutes).
If 14A and 1 is flashing follow these steps
- Press the ➕ button until 14C:0 is displayed.
- Press the ✔️ button. 0 should start flashing ⚡.
- Press the ➕ button. 1 should start flashing ⚡.
- Press the ✔️ button to SAVE and follow steps 3-8.
