Genius Echo TX4 Programming Notice
This document provides instructions for programming the Genius Echo TX4 remote control for 433 MHz systems.
How to Memorize This Remote Control at 433 MHz
Use 433 MHz remote controls only with a 433 MHz receiver module.
- Press the LOGIC (SW3) or SPEED (SW2) push button (colored red in the photo) to memorize the total opening (open A) or partial opening (open B) respectively, and keep it pressed.
- Also press the SETUP (SW1) push button (colored red in the photo).
- The corresponding LED will start blinking slowly for 5 seconds.
- Release both push buttons. During these 5 seconds, press the desired push button on the remote control.
- The LED will light up solid for 1 second, indicating that memorization has been completed, then it will start blinking again for an additional 5 seconds during which another remote control can be memorized.
- After 5 seconds, the LED turns off, indicating the end of the procedure.
- To add other remote controls, repeat the operation starting from step 1.
Thank you for choosing AlloTelecommande
Programming Your New Remote Control
Programming from an already programmed remote control:
With your already programmed remote control and your new remote control, approach your receiver.
- On the already programmed remote control, simultaneously press buttons P1 and P2 and keep them pressed until the two LEDs L1 and L2 on the receiver blink. Release the buttons.
- While the two receiver LEDs are blinking, on the old remote control, press the button to copy. The LED (L1 or L2) associated with the button blinks.
- While the LED is blinking, on the new remote control, press the button to be programmed. The receiver LED blinks and then becomes solid. Release the button.
- After 10 seconds, the receiver LED turns off.
- Your new remote control is programmed.
Thank you for choosing AlloTelecommande
