Oricom UHF182XP 5 Watt UHF CB Radio
With Smart Dual Antenna System
An Oricom UHF182XP 5 Watt UHF CB Radio controller microphone is shown in use by a person in a 4WD vehicle driving on a dusty track in an outdoor, rugged environment. The radio features a Smart Dual Antenna System [dual antenna], an intuitive jog wheel for navigation [jog wheel], and a large backlit display [display].
Get the best from two antennas without the need for an additional switch. Whether you're in the high country, in rough terrain or on the flat, Oricom's Smart Dual Antenna Technology makes sure you stay in touch with all the features you'd expect from a 5 Watt UHF CB Radio.
The system allows connecting two antennas [connect two antennas].
The product is backed by a 5-year warranty [warranty].
The radio is designed to automatically receive the strongest signal [auto-signal].
Key Features
- Integrated (DAS) Dual Antenna System
- Heavy duty controller speaker microphone
- Open, priority and memory scanning
- 5 Memory channels
- Over/under voltage alert function
- 38 CTCSS and 104 DCS codes
- 3 Colour backlit display (2 levels of brightness)
- Audio scrambler
- Triple watch
- Automatic power off
- Duplex (range extender)
- Volume, channel and squelch control
- External speaker jack (3.5mm)
- Requires at least one antenna (not supplied)
- Designed and engineered in Korea
Mechanical Specifications
Dimensions (H x W x D): 29mm x 110mm x 115mm
The unit features connection ports for two antennas, labeled ANT1 and ANT2 [antenna connections].
Technical Specifications
Transmitter
| RF Output Power | 5 Watts max |
| Modulation | F3E(FM) |
| Maximum deviation | 2.5KHz |
| Spurious Emissions | <-30dBm |
| TX Audio pre-emphasis | +6dB/Octave from 300Hz to 3KHz |
| Current consumption during TX | 1.6 AMP with 50 ohm antenna termination |
Receiver
| Circuit Type | Direct conversion by single DSP Chip |
| Intermediate Frequencies | 137kHz |
| Maximum useable sensitivity | Less than -122dBm for 12dB SINAD un-weighted |
| Audio output power | > 2 Watts at 8 ohm load |
| RX Audio de-emphasis | +6dB/Octave from 300Hz to 3KHz |
| Signal to Noise Ratio | > 40dB |
| Conducted Spurious Emission | > -57dBm |
General Specifications
| Compliance | AS/NZS 4365:2011 |
| Frequency Range TX/RX | 476.425 - 477.4125 MHz |
| Number of TX/RX Channels | 80 UHF CB Channels (75 voice) |
| Channel Spacing TX/RX | 12.5KHz |
| Operating modes | Simplex, Repeater TX offset (+750kHz) |
| Scanning Speed | 130 msec per channel |
| Antenna Impedance | 50 Ohms for ANT1, ANT2 |
| Operating Volts nominal | 13.8VDC |
| Operating Volts Range | 10 to 15VDC |
| Over Voltage Protection | Diode and Voltage regulator system |
| Over Current Protection | 2 AMP fuse |
| Reverse Polarity Protection | Shunt diode |
| Frequency stability | +/- 5 ppm |
