Oricom UHF395 5 Watt UHF CB Radio Controller Speaker Microphone
The Oricom UHF395 offers a revolutionary design that integrates all radio controls into the microphone, eliminating the need for a separate head unit. This setup provides exceptional sound quality and volume through its integrated speaker in the controller microphone and the transceiver speaker.
Key Features
- 5 watt (max TX power)
- Heavy duty controller speaker microphone
- Rugged micro size transceiver
- Large easy to read LCD display
- Dual speaker in transceiver and microphone
- Automatic Level Control (ALC) for consistent audio levels
- 3 Colour backlit display
- 38 CTCSS and 104 DCS codes
- Duplex (range extender)
- Open/Priority scan Priority channel
- Designed for Australian conditions
- Made in Korea
Technical Specifications
General
- Compliance: AS/NZS 4365:2011
- Frequency Range TX: 476.425-477.4125MHz
- Number of TX/RX Channels: 80 UHF CB Channels (75 voice)
- Channel Spacing TX/RX: 12.5KHz
- Operating modes: Simplex, Repeater TX offset (+750kHz)
- Scanning Speed: 130 msec per channel
- Antenna Impedance: 50 Ohms
- Operating Volts Range: 10 to 15VDC
- Over Voltage Protection: Voltage regulator
- Over Current Protection: 2 AMP fuse
- Reverse Polarity Protection: Shunt diode
- Frequency stability: +/- 2.5 ppm
Transmitter
- RF Output Power: 5 watts
- Modulation: F3E(FM)
- Maximum deviation: 2.5KHz
- Spurious Emissions: <-70dBc
- TX Audio pre-emphasis: +6dB/Octave from 300Hz to 3KHz
- Current consumption during TX: 1.5 AMP with 50 ohm antenna termination
Receiver
- Circuit Type: Direct conversion by Single DSP chip
- Intermediate Frequencies: IF = 137KHz
- Maximum useable sensitivity: Less than -122dBm at 12dB SINAD
- Audio output power: 3 Watts Maximum
- RX Audio de-emphasis: -6dB/octave 300Hz to 3kHz
Mechanical
- Transceiver Dimensions: 27 (h) x 102 (w) x 85 (d) mm
- Weight: 420gms
The UHF395 features a micro size for easy installation and comes with a 5-year warranty. Oricom is 100% Aussie Owned.
For more information, visit oricom.com.au.