User Manual for Tizwis models including: CL-V11, CL-V11SE, CL-V11R, CL-V11 LED Fill Light, LED Fill Light, Fill Light, Light
Tizwis 60 LED Phone Light with Front & Back Clip, Selfie Light with CRI 95 , Selfie Light for iPhone, iPad, Phone, 3000Mah Portable Light, Adjusted 3 Light Modes for Selfie, Vlog, Makeup, TikTok : Cell Phones & Accessories
RTHJK1 : Celulares y Accesorios
110 80 LED Fill Light CL-V11/CL-V11SE/CL-V11R User's manual Preface Thank you for purchasing our products! This is an ultra-thin fill light, which is compact and convenient to use. This product can be used for fill light in mobile phones and laptops, with a variety of color temperature/brightness adjustable,Built-in 3000mAh battery can provide about 2 hours of continuous lighting. 1Product introduction 234 5 6 Please read this manual carefully before use, and keep it for future reference after reading. 9 Matters needing attention 1. This fill light does not have waterproof and dustproof functions. 2. Do not let this fill light be strongly impacted. 1 10 3. Do not look directly at the light-emitting surface of the fill lamp in use for a long time in a static distance, or it may damage your vision. 4. After charging, unplug the power cord. 5. After not using this product for a long time, the battery should be fully charged before using this product again, otherwise it may lead to no power and unable to start. 6. In order to extend the service life of the battery, it is recommended to charge and maintain it every three months. 7. This product has a built-in rechargeable lithium battery, which has a certain life limit. After a certain period of use, the performance will be reduced, which is a normal 7 phenomenon. 11 8 13 12 1 Luminous surface 2 Type-c charging port 3 Micro-usb charging port 4 Value decrease button 5 Value increase button 6 Power/mode switch 7 Retaining clip 1 8 Angle adjustment knob 9 Indicator/display 10 Retaining clip 2 11 Fixed knob 12 1/4 screw hole 13 Parameter switching 2Product installation Fixing clip 1 It is fixed through 1/4 screw hole and can be fixed by screwing the knob. (Compatible with other accessories linked by 1/4 screw) Fixing clip 2 1. First install the single leg of the fixing clip into the slot on the back of the fill lamp 2. Then push the fixing clip towards the direction of both feet until the two feet of the fixing clip are also installed in the slot of the fill lamp 3. Screw out the mobile phone mounting base of fixing clip 2 4. Place the mobile phone in the direction as shown in the figure 1 2 3 4 5 3Function and display CL-V11 ON/OFF Press and hold the power button for 3 seconds, and the fill light will turn on. Press and hold the power button again for 3 seconds to turn off the light. Parameter settings Briefly press the "M"button to Toggle color temperature/brightness options.Use the "+"/"-" buttons to adjust the parameter values. Charge When using Type-c or Micro-usb interface to charge, the battery indicator will flash in flowing water,When the indicator is no longer flashing, it means that the charging is completed. CL-V11SE ON/OFF Press and hold the power button for 3 seconds, and the fill light will turn on. The default is white light mode.Press and hold the power button again for 3 seconds to turn off the light. Mode switching Briefly press the power button to switch between warm light, cold light and white light. Brightness adjustment In any mode, use the "+"/"-" keys to adjust the brightness, which can be adjusted by 10 levels. Charge When using Type-c or Micro-usb interface to charge, the battery indicator will flash in flowing water,When the indicator is no longer flashing, it means that the charging is completed. CL-V11R ON/OFF Press and hold the power button for 3 seconds, and the fill light will turn on. Press and hold the power button again for 3 seconds to turn off the light. Mode switching Briefly press the power button to switch modes, CCT/HSV/ special effect, and three modes are switched. Parameter adjustment In any mode, briefly press the "M" key to switch between different parameters, and use the "+"/"-" keys to adjust the parameter values Special effect mode Support 24 kinds of special effects. Charge When using Type-c or Micro-usb interface to charge, the battery indicator will flash in flowing water,When the indicator is no longer flashing, it means that the charging is completed. 4Specifications Model Colour Brightness LED Qty i l l u m i n a n c elux CL-V11 2500 K- 9000K± 200K 0-100% 60pcs 2500K 4500K 9000K 0.3m 900 distance 0.5m 350 1200 500 1000 400 CRI TLCI Battery Power Duration Input Charging port Fixed interface Size Weight Accessories 95 97 3. 7V 3000m Ah11. 1Wh 5W About 1.5 hours 5V/1A Ty p e - C/Micro-usb 1/4 screw hole, retaining clip 1, retaining clip 2 104*75*11.8mm About 140g LEDlight*1, Type-C charging cable*1, fixing clip 1, fixing clip 2 The specifications and parameters of this product are tested in accordance with the company's laboratory samples. The finished product may have some differences ,which will not affect the normal use; if the design and specifications changed will not prior notice. Model Colour Brightness LED Qty i l l u m i n a n c elux CL-V11SE 2500 K/4500K/9000K± 200K 10 levels adjustable 60pcs 2500K 4500K 9000K 0.3m 900 distance 0.5m 350 1200 500 1000 400 CRI TLCI Battery Power Duration Input Charging port Fixed interface Size Weight Accessories 95 97 3. 7V 3000m Ah11. 1W h 5W About 1.5 hours 5V/1A Ty pe - C/Micro-usb 1/4 screw hole, retaining clip 1, retaining clip 2 104*75*11.8mm About 140g LEDlight*1, Type-C charging cable*1, fixing clip 1, fixing clip 2 The specifications and parameters of this product are tested in accordance with the company's laboratory samples. The finished product may have some differences ,which will not affect the normal use; if the design and specifications changed will not prior notice. Model CL-V11R CCT 2500K- 9000K± 200K Brightness Br i g h t n e s s a d j u s t m e n t r a n g e0 -1 0 0% LED Qty RGB:30pcs BI48pcs illuminanceluxW a r m l i g h t C o l d l i g h t Red Green Blue 0.3m 900 1000 200 100 400 distance 0.5m 350 400 80 40 180 CRI TLCI RGBHSV Special effect Battery Power Duration Input Charging port Fixed interface Size Weight Accessories 95 97 0- 359F u l l c ol or 24 kinds 3. 7V 3000m Ah11. 1Wh 5W About 1.5 hours 5V/1A Ty p e -C/Micro-usb 1/4 screw hole, retaining clip 1, retaining clip 2 104*75*11.8mm About 140g LEDlight*1, Type-C charging cable*1, fixing clip 1, fixing clip 2 The specifications and parameters of this product are tested in accordance with the company's laboratory samples. The finished product may have some differences ,which will not affect the normal use; if the design and specifications changed will not prior notice.Adobe PDF library 15.00 Adobe Illustrator(R) 24.0