DSP5011 6.5 inch Frameless Ceiling Speaker
Manufacturer: Guangzhou DSPPA Audio Co., Ltd
Features
- 20 cores magnetic steel for high-quality sound effect
- Super-strong reproduction of voice and music
- Fashionable thin-edge, plane, and big cylinder design
- Easy installation, suitable for ceilings of different thickness
- UV-level highly flame retarding
- Frequency response: 65Hz-20kHz
- Maximum SPL: 103±2dB
- High sensitivity: 95±2dB
- Distortion: <1.5%
Description
The DSP5011 Frameless Ceiling Speaker features a fashionable thin-edge plane big cylinder design and a carbon alloy aluminum mesh with RAL white coating, allowing it to integrate perfectly into any indoor space. It is equipped with a 6.5" full-range loudspeaker. The magnetic circuit is encapsulated with special engineering plastic, and the drum paper is formed through tripping and hot pressing of algae salved organisms, ensuring super-strong reproduction of voice and music. The speaker conforms to the IEC 268-5 power handling capacity (PHC) standard and is designed for continuous operation for 100 hours, including simulating acoustic feedback exposure (SAFE) tests. It can withstand double rated powers for short periods, ensuring high reliability under extreme conditions, prolonging service life, and minimizing the risk of performance degradation.
Specifications
| Specification | Value |
|---|---|
| Loudspeaker | 6.5"*1 |
| Effective frequency range | (65~20k) Hz |
| Rated power (100V line) | 6W |
| Maximum power | 10W |
| Rated impedance | 100V line: 10W*, 6W, 3W; 70V line: 6W, 3W, 1.5W |
| Maximum sound pressure level | 103dB±2dB |
| Characteristic sensitivity (1m/1w) | 95dB±2dB |
| Storage temperature | -25°C~+55°C |
| Outline dimension | 185mm*69mm |
| Weight | 0.75Kg |
Visual Data Descriptions:
Frequency Response Graph: A graph displays the speaker's frequency response from 50Hz to 20kHz, with sound pressure level (SPL) measured in dBSPL on the y-axis, showing a relatively flat response across the audible spectrum.
Distortion Characteristic Graph: A graph illustrates the speaker's distortion characteristics from 50Hz to 20kHz. The left y-axis shows dBSPL, and the right y-axis shows distortion percentage (%). The graph indicates low distortion levels, especially at higher frequencies.
Installation Method
- Cut an installation hole in the ceiling with a diameter of 165-170mm.
Visual Aid Description: Diagram showing the speaker's outline dimensions (185mm diameter, 69mm height) and the required installation hole size (165-170mm diameter).
- The spring clip height is suitable for ceilings of different thicknesses.
- Connect the audio broadcast transmission line. Select the suitable terminal connection according to the table below, based on the required actual power.
Terminal Line voltage Power Black --- Blue 70V 1.5W Black --- Yellow 70V 3W Black --- White 70V 6W Black --- Blue 100V 3W Black --- Yellow 100V 6W Black --- White 100V 10W* Note: The connection method marked with "*" is used only for longer transmission distances and larger line consumption.
- Upturn the spring clips of the loudspeaker at both sides and insert them into the installation hole. Release the clips, then gently push the loudspeaker into the ceiling.
Visual Aid Description: Diagrams illustrating the operation of the spring clips for installation.
Safety Note: To prevent injury from the spring clips, it is recommended to wear working gloves during this operation.
- Finally, inspect the installation to ensure it is firm and reliable.
