XSY330 Multipurpose Solar Radio

Contents

• RADIO OPERATION
• 3 POWER METHODS
• POWER INDICATOR
• READING LAMP
• SOS ALARM
• FLASHLIGHT
• CHARGE & DISCHARGE FUNCTION
• WARRANTY
• SPECIFICATION
• FRIENDLY REMINDER
• PACKING LIST

RADIO OPERATION

Turn the "Volume" Dial clockwise to power on the radio and adjust the volume.

Select FM/AM/WB with the radio band switch.

Extend the antenna to get better signal reception, especially listening to the FM and NOAA broadcasts.

Turn the Tuner Dial to select a station. The Green tune indicator lights up when the selected station is fully engaged.

Turn the "Volume" dial to the OFF position and the radio is turned off.

Controls: Volume Dial, Solar Panel, Compass, Band Switch, Tuner Dial

FLASHLIGHT

Pressing the flashlight button cycles through three modes: high beams only, dipped beams only, both high and low beams, and off.

Modes: Far and Dipped Beam

READING LAMP

Open the solar panel and turn on the reading light button to activate the reading lamp. Close the solar panel and press the button again to turn it off.

CHARGE & DISCHARGE FUNCTION

The waterproof cover on the side of this product has a USB output port and a USB input port.

Connect a USB device with the USB output port via a USB cable to power the USB device. When the device is used as a power bank (discharge), the power indicator lights will diminish.

Notes:

• For charging your phone, use the corresponding cable.
• If charging fails, disconnect and reconnect the USB cable to activate power output.
• This function is recommended for emergency use only; do not use it as a normal power bank.

Ports: USB Input, USB Output

SOS ALARM

Press and hold the SOS button for 3 seconds to activate a loud siren and flashing beam. Press the SOS button again to turn it off.

ANTENNA

A stretchable antenna is located on the right side of the radio. Extend it fully for better signal reception when listening to FM/AM/WB channels.

3 POWER METHODS

A. USB charging

Connect the supplied USB cable to the Input port on the right side of the unit to charge the built-in lithium battery. Four blue power indicator lights will illuminate sequentially.

Note: Please charge the radio at least once every three months.

B. Hand Crank

Charge the radio by turning the handle at the bottom of the device to activate the dynamo. Turning the handle for 3 minutes at 120 rpm provides approximately 4 minutes of beam illumination or 15 minutes of radio playback.

Note: Hand-crank charging is recommended for emergencies. USB charging is generally preferred for the lithium battery.

C. SOLAR POWER

Expose the solar panel to direct sunlight for efficient charging. A red power indicator light illuminates when the radio is receiving enough sunlight to begin charging. This method is primarily for maintaining the battery and prolonging its life.

POWER INDICATOR

This unit features four power indicator lights (25%, 50%, 75%, 100%) to display the power capacity. The indicator lights remain on during charging and discharging.

SPECIFICATION

Frequency Range: AM: 520-1710KHz, FM: 87-108MHz, WB: 162.400-162.550 MHz

Dimensions: 16*9*8cm / 6.3*3.5*3.1In

Weight: 500g / 1.1 lb

Power Source: 10000mAh, 3.7V Lithium Battery

Solar Power: 5V 0.3W

Hand Crank: 5V 1.5W

USB Input: DC 5V 2.5A

USB Output: DC 5V 2A

LED Flashlight: Far beam: 600LUX, Dipped beam: 150LUX, Mixed beam: 650LUX

Battery Life (Fully Charged): Radio: 90H, Radio & LED lighting: 30H, Radio & reading lamp: 9H

Note: Actual usage time may vary slightly from reported data due to differences in usage environments.

WARRANTY

The device comes with a 12-month warranty against manufacturing defects from the date of purchase.

PACKING LIST

• Radio x 1
• User Manual x 1
• USB Cable x 1

FRIENDLY REMINDER

• For first-time use or if the unit has been idle for over 60 days, hand crank for 1 minute to activate the internal battery.
• The device should not be exposed to dripping or splashing, and no objects filled with liquids should be placed on it.
• Avoid over-discharging the unit to prevent reducing internal battery life or damaging the battery.
• Do not direct the flashlight beam into eyes, as it can cause harm.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.