Laresar Elite S6 Cordless Vacuum Cleaner User Manual

1.1 Precautions During Use

• 01. This Laresar machine is not intended for use by persons (including children) with reduced physical, sensory, or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning the use of the machine by a person responsible for their safety.
• 02. Use only as described in this Laresar user manual. If the machine is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, do not use it and contact the Laresar support team.
• 03. Suitable for dry locations ONLY. Do not install, charge, or use this machine outdoors, in a bathroom, or within 10 feet (3 meters) of a swimming pool. Do not use on wet surfaces and do not expose to moisture, rain, or snow.
• 04. When using this machine, please keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts. Do not point the hose, aluminum alloy tube, or other accessories at your eyes or ears, and do not put them in your mouth.
• 05. Do not use to pick up hard objects, such as glass slag, needles, nails, etc.
• 06. Do not touch the charger with wet hands to avoid electric shock.
• 07. Use only accessories and spare parts recommended by Laresar.
• 08. Do not operate without the dustbin and filter(s) in place.
• 09. When removing or replacing a motorized brush bar, be careful not to pull the power button while the cleaning head has not been reassembled.
• 10. Do not spray or spill liquid onto the vacuum cleaner. If this happens, it will increase the risk of electric shock.
• 11. Exercise extreme caution when cleaning on stairs.
• 12. Please do not use the vacuum cleaner to suck up detergent, kerosene, soot, wet dust, water, wastewater, matches, and other items.
• 13. Please do not use a vacuum cleaner to suck up small particles such as cement, gypsum powder, wall powder, or large objects such as paper balls, otherwise the vacuum cleaner will be blocked and the motor will burn out.

1.2 Battery Notes

• 01. Do not dispose of the battery, and it must be safely discarded in accordance with local regulations.
• 02. Do not use a damaged or modified battery or machine. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
• 03. Do not incinerate batteries or expose them to high temperatures, as they may explode.
• 04. The battery is a sealed unit and under normal circumstances does not pose a safety problem. In the unlikely event that liquid leaks from the battery, do not touch the liquid as it may cause irritation or burns, and observe the following precautions.
  • Contact with skin - may cause irritation. Wash with soap and water.
  • Inhalation - may cause respiratory irritation. Expose to fresh air and seek medical attention.
  • Eye contact - may cause irritation. Immediately flush eyes with plenty of water for at least 15 minutes. Seek medical assistance.
  • Disposal - wear gloves to handle the battery and dispose of it immediately, in accordance with local ordinances or regulations.
• 05. When the battery is not in use, keep it away from paper clips, coins, keys, nails, screws, or other small metal objects that could establish a connection from one terminal to another.

1.3 Charging Notes

• 01. Before use, check that the charger cord shows no signs of damage or aging. A damaged or tangled charger cord increases the risk of fire and electric shock.
• 02. Do not modify the charger in any way.
• 03. The charger has been designed for a specific voltage. Always check that the mains voltage is the same as that indicated on the nameplate.
• 04. Unplug the charger when not in use for extended periods.
• 05. When your vacuum cleaner is fully charged, needs to be cleaned or repaired, please unplug the charger in time and do not pull directly on the power cord.
• 06. Do not pull on the cord to disconnect from an outlet, grasp the plug and pull to disconnect.
• 07. Do not wrap the cord around the charger when storing.
• 08. Please fully charge the battery for the first use or after prolonged storage. If the product is not used for a long time, please ensure the battery is recharged and used at least every three months.
• 09. If smoke or fire occurs during charging, immediately unplug the charger and use a fire extinguisher to put out the fire. Do not use water to extinguish the fire, as it will increase the risk of electric shock.
• 10. Follow all charging instructions and do not charge the battery or machine outside the specified temperature range in the instructions. Incorrect charging or charging at a temperature outside the specified range can damage the battery and increase the risk of fire. To ensure maximum battery life, Laresar recommends the following:
  • When not in use, the machine should be stored at room temperature. Recommended range: 64°F (18°C) to 82°F (28°C).
  • The ambient temperature range for operation and charging should be between 50°F (8°C) and 86°F (35°C).

1.4 Storage and Maintenance Precautions

• 01. Please store the product in a cool, dry environment. Please avoid prolonged sunlight on the product.
• 02. The charger must be removed from the outlet before removing the battery, cleaning, or servicing the appliance.
• 03. Please use a dry cloth to clean the vacuum cleaner. Please do not use gas or liquid that may crack the surface or cause discoloration.
• 04. Do not apply any perfume or scented products to the filter(s) of this machine. Chemicals in these products are known to be flammable and may cause a fire in the machine.
• 05. Do not perform any maintenance other than that indicated in this manual or advised by the Laresar support team.
• 06. Do not disassemble the machine as incorrect reassembly may result in electric shock or fire. Contact the Laresar support team when service or repair is needed.

3.1 Overview

Introduction of Components:

1. Animated Displays
2. Scent Purification
3. Dust Cup Release Button
4. Dust Emptying Button (Note: This may refer to a specific dust release mechanism or be redundant with button 03 depending on design.)
5. Main Unit Release Button
6. Telescopic Wand Adjustment
7. Electric Brush Head Release Button
8. Speed Button
9. Switches (Power)
10. Battery Removal Button

3.2 Animated Screen Indicator

• Charging Indication ⚡
• Suction - Low ?
• Suction - Medium ?
• Suction - High ?
• Low Battery Reminder ?
• Incorrect Adapter ?❌
• Brush Roll Detachment ⚙️ (Indicates potential issue with brush roll)
• Airway Blockage ?❌ (Indicates a blockage in the vacuum path)

4.1 Product Assembly

4.1.1 Battery Installation

Ensure the battery is fully charged before first use. Slide the battery onto the designated slot on the main unit until it clicks into place. To remove, press the battery removal button.

4.1.2 Accessory Installation

Attach the telescopic tube to the main unit. Attach the desired cleaning head (e.g., motorized brush head, crevice nozzle) to the end of the telescopic tube or directly to the main unit as needed.

4.2 How to Use

Before use, ensure:

• The battery is fully charged and securely attached.
• The dustbin and filters are clean, dry, and properly installed.

4.3 Exception Indicators

• When the battery is low, the screen flashes a red animation to remind you it's time to recharge. ?
• When the floor brushes are blocked, the screen displays a blocked rotor check animation, prompting you to remove the drum and clean debris. ⚙️
• After a complete motor blockage for 5 seconds, the machine stops operating and the screen displays an error message 90 seconds later to turn off or restart the machine. Please detach the vacuum and check that the brush, hose, and filter are not obstructed.
• When the wrong adapter is used, the screen plays an error animation for 60 seconds, then turns off. The animation indicates that the adapter parameters are correct. ?❌

5.1 Charging Methods

When the battery indicator on the screen is below 30% and the device is off, the product needs to be recharged promptly.

Method 1: Charging on the Wall Mount

The product can be charged on the storage wall mount. The digital screen indicates the charging process; when the battery is at 100%, it is full. ⚡

Method 2: Charging the Battery Separately

The entire battery can be removed and charged separately. The battery indicator light flashes blue during charging and turns solid blue when the battery is full.

• Blue light flashes (Charging) ⚡
• Solid blue light (Fully Charged) ✅

5.2 Wall Mount

Hold the charging wall mount against the wall through the two fixing screw holes and secure it to the wall with screws, then hang the vacuum cleaner on the wall.

Warning

• Please ensure there are no gas, water, or electrical cables and wires behind the mounting area.
• To prevent the docking station from falling, please ensure it is installed firmly.

6.1 Cleaning the Main Body

• Turn off the device before cleaning the body.
• Please use a neutral detergent, wipe the body with a semi-damp cloth.
• Please avoid sun exposure and store in a cool, dry place.

6.2 Emptying the Dustbin

Press the dustbin release button to empty the dust. If the waste in the dustbin exceeds the MAX line during use, please empty it promptly. MAX ?️

6.3 Cleaning the Filter

The dustbin release lever is pulled backward, and the dustbin can be disengaged and unlocked for cleaning.

Note:

• Wash the filters with cold water at least once a month.
• Please use a cleaning brush to remove dust from the surface of the HEPA filter before rinsing it with water.
• Please ensure the filters are completely dry before reassembling them.

6.4 Cleaning the Brush Roll

Note: After long periods of use, hair or similar accumulation may get stuck. It is recommended to periodically clean the brush roll to ensure efficient operation and maintain suction.

Federal Communication Commission Interference Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

We (EU based importer is responsible for this declaration)

Prolinx GmbH (Company name)
Brehmstr.56, 40239 Duesseldorf, Germany (Company address)

declare under our sole responsibility that the product

Trade name: Laresar
Equipment: Vacuum Cleaner
Model No.: Elite S6

to which this declaration relates is in conformity with the essential requirement set out in the Council Directive on the Approximation of the laws of the Member States relating to LVD Directive(2014/35/EU) & EMC Directive(2014/30/EU) & RoHS(2011/65/EU). The product is responsible for affixing the CE marking. The following standards were applied:

EN 60335-2-2:2010+A11:2012+A1:2013
EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A14:2019+A2:2019
EN 62233:2008
EN 55014-1:2021
EN 55014-2:2021
EN IEC 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A2019
IEC62321-3-1:2013
IEC62321-4:2013
IEC62321-5:2013
IEC62321-6:2015
IEC62321-7-1:2015
IEC62321-7-2:2017
IEC62321-8:2017

Full Name: George.wang
Signature: [Signature Placeholder]
Position: Approbation Manager
Place/Date: Shenzhen, China/Feb.01-2023