Instruction Manual for EPH Controls models including: CDTP2 Room Thermostat Hardwired, CDTP2, Room Thermostat Hardwired, Thermostat Hardwired, Hardwired
File Info : application/pdf, 1 Pages, 965.27KB
DocumentDocumentCDTP2 Room Thermostat Hardwired Boiler Plus Page 1 of 1 Installation Instructions For use in normal environments. CAUTION! Installation and connection should only be carried out by a qualified person and in accordance with national wiring regulations. Before commencing any work on the electrical connections, you must first disconnect the thermostat from the mains. None of the 230V connections must be live until the installation has been completed and the housing is closed. Only qualified electricians or authorised service staff are permitted to open the thermostat. There are parts that carry mains voltage behind the cover. The thermostat must not be left unsupervised when open. (Prevent non specialists and especially children from gaining access to it.) If the thermostat is used in a way not specified by the manufacturer, its safety may be impaired. Prior to setting the thermostat, it is neccessary to complete all required settings described in the section. This thermostat can be mounted in the following ways: 1) To a recessed conduit box 2) To a surface mounted box 3) Directly mounted on wall 1 2 Important: Keep this document 3 4 5 6 EPH Controls Ireland technical@ephcontrols.com www.ephcontrols.com EPH Controls UK technical@ephcontrols.com www.ephcontrols.co.uk 20221006_CDTP2_InsIns_PK