DS18 TLV6 Portable Party Speaker

Introduction

Welcome to the DS18 TLV6 Portable Party Speaker. To achieve the best performance, please read this instruction manual carefully before using, and keep it for future reference.

Safety Information

Risk of Electric Shock, Do Not Open

Caution: To reduce the risk of electric shock, do not open this device. There are no serviceable parts for customers. Please refer any maintenance or repair to qualified personnel.

Symbol Explanation:

• ❗ This symbol means that there are important instructions of operation and handling in the manual that comes with this device.
• ⚡ This symbol means the existence of dangerous voltage inside the unit, which states a risk of electric shock.

General Warnings

• Never remove the casing of this device.
• Never lubricate any part of this device.
• Never place this device on top of other electrical equipment.
• Make sure that you always have easy access to the power cord, or adapter to disconnect the device from the power.

Important Notices Before Using This Speaker

• Read and keep these instructions.
• Read and follow all warnings.
• Do not use this device near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings.
• Install in accordance with the manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat.
• Only use attachments/accessories specified by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the device. When a cart is used, use caution when moving the cart/device combination to avoid injury from tip-over.
• Unplug this device during lightning storms or when unused for long periods of time.
• Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way (e.g., power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the device, the device has been exposed to rain or moisture, does not operate normally, or has been dropped).

Battery Usage Caution

To prevent battery leakage which may result in bodily injury, property damage, or damage to the remote control:

• Install all batteries correctly, observing the + and - polarity as marked on the remote control.
• Do not mix batteries (old and new or carbon and alkaline, etc.).
• Remove batteries when the remote control is not used for a long time.
• Do not expose batteries (battery pack or individual batteries) to excessive heat such as sunshine, fire, or the like.

• The device shall not be exposed to dripping or splashing of liquids.
• Do not place any sources of danger on the device (e.g., liquid-filled objects, lighted candles).

Hearing Safety

Caution: Listen at a moderate volume.

• Using headphones at a high volume can impair your hearing.
• Sound can be deceiving. Over time, your hearing comfort level adapts to higher volumes of sound. So, after prolonged listening, what sounds "normal" can be loud and harmful to your hearing. To guard against this, set your volume to a safe level before your hearing adapts and leave it there.

To establish a safe volume level:

• Set your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and clearly without distortion.

Listen for reasonable periods:

• Prolonged exposure to sound, even at normal "safe" levels, can also cause hearing loss.
• Be sure to use your equipment reasonably and take appropriate breaks.

Notice

Any changes or modifications made to this device that are not expressly approved by Consumer Lifestyle may void the user's authority to operate the equipment.

Product Overview

What's in the Box

• TLV6 Speaker
• Remote control
• User manual
• Aux In/ FM Antenna Cable
• AC Power Cable

Features

• Portable 6.5" 2-Way Bass-Reflex Loudspeaker with RGB LED Lights - Party Speaker
• Audio Sources: BT / USB / FM Tuner / Aux / Mic / Guitar
• Connectivity: Bluetooth with TWS (True Wireless Stereo)
• Playing time: 3.5 hours with Full power and LED Lights ON (results may vary depending on multiple conditions)
• Battery: Built-in Rechargeable Battery
• Charging time: From Low Battery <1 hour (Using AC input) - 2 hours (using 12V input)

Controls and Operation

Top Control Panel Overview

The top panel features the following controls:

1. AUX input: 3.5mm jack
2. USB port
3. Previous button (◄◄)
4. Next button (►►)
5. Tone button: Adjusts treble or bass volume.
6. Play - Pause button (►II)
7. Volume down button (-)
8. Guitar jack: 1/4" input for guitar.
9. Microphone jack: 1/4" input for microphone.
10. Lighting switching button: Controls lighting effects.
11. Standby button
12. Menu button
13. Mode switching button: Switches between modes (e.g., Bluetooth, AUX) and activates TWS function.
14. Volume up button (+)
15. FM presets up
16. FM presets down
17. Auto scan FM stations: Scans and saves FM stations.
18. Mute button
19. Bass EQ effect button

Rear Panel Overview

The rear panel includes:

1. Power ON/OFF Button
2. DC Input jack: For 12V power input.
3. Power Indicator light
4. AC Power Input jack: For connecting the AC power cable.

Remote Control Overview

The remote control allows operation from a distance. Key functions include power, input selection, playback control, volume adjustment, and mode switching.

Get Started: Connecting Power

Caution: Ensure that the power supply voltage corresponds to the voltage printed on the unit. Risk of electric shock: When unplugging the AC power cord, always pull the plug from the socket, never the cord.

Before connecting the AC power cord, ensure all other connections are completed. Connect the power cable to the wall socket.

Remote Control Preparation

To insert batteries into the remote control:

1. Open the battery compartment.
2. Insert 2 x AAA batteries with correct polarity (+/-) as indicated. (Batteries are not included; please purchase separately).
3. Close the battery compartment.

Notes:

• If the remote will not be used for a long time, remove the batteries.
• Do not mix old and new batteries, or different types of batteries.
• Batteries contain chemical substances and should be disposed of properly.

Turning Speaker On/Off

The speaker can operate using AC power input or the built-in DC battery.

• AC Mode: Connect the AC power cable to a wall socket and set the power switch on the rear panel to the ON position.
• DC Mode: Use the power adapter (not included in accessories) to power on the speaker and set the power switch on the rear panel to the ON position.
• The remote control can be used to put the speaker into standby mode; press it again to power it on.

Caution: If the unit is not used for a while, switch the "POWER" button to "OFF" and disconnect the AC power cable.

Charging the Internal Battery

1. Connect the power cable and plug it into the wall socket on the rear panel.
2. The BATTERY indicator light on the rear panel will illuminate RED while charging.
3. When the RED indicator light turns off, the battery is fully charged. Unplug the power cable to stop charging.

Internal Battery Level Indicator

The display shows the battery level in three stages. The level decreases as the battery is used.

• When only one level remains, charge the internal battery promptly to maintain battery life.
• If the speaker sound becomes abnormal, charge the internal battery promptly.

Note: For long-term storage, fully charge the product. Recharge once a month to maintain battery life.

Basic Key Play Operations

Control playback using the following buttons:

Connectivity

Connect with Bluetooth

1. Press the M/MODE button on the top panel or remote to switch to BLUETOOTH CONNECT mode (display shows "BLUE").
2. On your external device (with Bluetooth function), find and connect to "DS18 TLV6".
3. Once connected, you will hear a sound from the speaker.
4. Use the ◄◄ or ►► buttons on the top panel to control tracks.

Note: This speaker does not require a password.

TWS (True Wireless Stereo) Instructions

To use TWS, you need two identical speakers.

1. Turn on two party speakers and ensure both are in Bluetooth mode.
2. On your external device, open Bluetooth and connect to one of the speakers (e.g., "DS18 TLV6").
3. Once connected, long-press the M button on either speaker to automatically pair both speakers for TWS.
4. To disconnect TWS, long-press the Bluetooth button on either speaker. Long-press again to reconnect TWS.

FM Radio Instructions

1. Press the M button on the top panel or "FM" on the remote to switch to FM mode.
2. Press SCAN or ►II on the top panel or remote to automatically search and save radio stations.
3. Use NEXT and PREV buttons to select programmed radio stations.

Connect with AUX Line-In

1. Press the M/MODE button on the top panel or remote to switch to AUX (Line) mode (display shows "LINE").
2. Connect the speaker to your external device's earphone jack using the provided AUX cable.
3. Turn on your external device's music.
4. Use the ◄◄ or ►► buttons on the top panel to control tracks.

Caution: Turn off the unit before connecting the AUX cable to avoid unexpected noise.

Connect with Wired Microphone/Guitar

When playing with a wired microphone or guitar, use the volume knob to adjust the sound level.

• Microphone/Guitar Volume: Press the MIC/GT MENU button to access microphone/guitar volume control. Use the volume +/- buttons to adjust the level.
• Microphone Echo Volume: Press the MIC/GT MENU button again to access the microphone echo volume control. Use volume +/- to adjust.
• Microphone Treble/Bass Volume: Press the MIC/GT MENU button again to access microphone treble or bass volume control. Use volume +/- to adjust.

Important Notes for Microphone Use:

• Avoid placing the microphone directly opposite the speaker's bass port, as this may cause whistling noise.
• For best singing performance, keep the microphone 5-15 cm from your mouth at a 45-degree angle.
• Always pay attention to the battery status when using the microphone.

If the battery is low, an indicator light will come on, and performance will degrade.

Caution: Do not point the microphone directly at the speaker, as this may damage the speaker.

Troubleshooting

No Power

• Ensure the AC power plug is properly connected.
• Verify that the AC outlet has power.

No Sound or Poor Sound

• Adjust the volume.
• Disconnect headphones.
• Check that speakers are connected correctly.
• Ensure speaker wires are securely clamped.

No Response from Speaker

Disconnect and reconnect the AC power plug, then turn the speaker on again.

Remote Control Not Working

• Before pressing any function button, select the correct source using the remote control, not the main unit.
• Reduce the distance between the remote control and the unit.
• Ensure batteries are inserted with correct polarity (+/-).
• Replace the batteries.
• Aim the remote control directly at the sensor on the front of the speaker.

Specifications