IKEA FLOALT LED Light Panel
Installation and User Guide
Important Safety Information
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.
The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
Assembly Instructions
Follow these steps carefully to assemble and install your FLOALT LED light panel:
- Prepare the Panel: Ensure the power is off. Identify the correct panel for your setup.
- Connect Power: Carefully open the panel to access the connection points. Connect the power supply cord (sold separately) to the designated terminals. Refer to the diagrams for correct wire placement (N for Neutral, L for Live).
- Secure the Panel: Mount the panel to the desired surface using appropriate screws and plugs suitable for your wall material. Ensure the panel is securely fastened.
- Connect Additional Units (if applicable): If you are combining multiple FLOALT panels, follow the diagrams to connect them using the appropriate connection cords (sold separately). Note the maximum limit of 10 LED units per combination.
- Final Connections: Once all panels are mounted and connected, close the panel securely. Ensure all connections are properly made before restoring power.
Diagrammatic Representation of Assembly Steps:
The document includes detailed diagrams illustrating each step of the installation process. These include:
- A visual representation of the FLOALT panels and the TRÅDFRI control.
- Step-by-step illustrations showing how to open the panel, connect wires, and secure the unit.
- Close-ups of connection terminals and screw points.
- Illustrations demonstrating how to connect multiple panels together.
- A diagram showing the placement of the CR2032 battery in the TRÅDFRI control.
- Measurements for positioning the TRÅDFRI control relative to the LED panels.
Product Information
TRÅDFRI Control: The TRÅDFRI control is used to manage the LED light panels. It requires a CR2032 battery (included) and should be placed within a certain range of the panels (e.g., max 5 cm from the panel, or specific X and Y coordinates as indicated in the diagrams).
Combinations: You can combine a maximum of 10 LED units in one combination. Ensure you use the correct power supply cords and intermediate connection cords, which are sold separately.
Troubleshooting and Support
If you encounter any issues during installation, please refer to the diagrams for guidance. For further assistance, contact IKEA customer support.
