InCarTec 27-241: Retain Original Camera on Fiat U-Connect
Product Designation: Designed for use with InCarTec Steering Wheel Control Interface 39-FIA-03
Installation Instructions
- Verify the vehicle's wiring is compatible with this adapter. The original camera should be connected to pins 31, 32, and 33 on the male connector of the vehicle's wiring harness. Note that wiring colours may vary. (Refer to Description of Image A).
- Connect the terminals of the 27-241 camera retention adapter to the ISO lead or steering wheel control interface. Connect the yellow lead to pin 21 and the black lead to pin 22. (Refer to Description of Image B). Pin numbers are visible on the inside of the connector.
- Connect the ISO lead or steering wheel control interface to the corresponding connection point in the vehicle.
- Connect the yellow RCA plug to the reverse camera input of the aftermarket radio. Subsequently, connect the radio's reverse wire to the reverse output of the ISO lead or steering wheel control interface.
Visual Aid Descriptions
Description of Image A: A close-up photograph of a vehicle's wiring harness, displaying a bundle of multi-colored wires. An orange circle highlights a specific group of pins, labeled as 31, 32, and 33.
Description of Image B: A photograph of a black electrical connector with attached wires. An orange circle draws attention to a yellow wire connected to pin 21 and a black wire connected to pin 22.
Important Terminal Insertion Note
The terminals are designed for one-way insertion only. Do not attempt to force them if they are upside down. Ensure they are fully inserted; a proper connection will result in an audible click.
