Installation Guide for SAFE VIEW models including: SV30API Smart RV Power Inlet, SV30API, Smart RV Power Inlet, RV Power Inlet, Power Inlet, Inlet
SafeView Smart RV Power Inlet - 30 amp - Hughes Autoformers Installation Instructions Inlet Manual
SV30API CONSUMER INSTALLATION GUIDE Turn off Rv's main breaker. Use a screwdriver to loosen and remove the four screws and pull out the old inlet out of the RV. Loosen screws and disconnect the old inlet to any wires. Mark and drill new holes if needed *TOOLS: On the SafeView Power Inlet, loosen the screw on the rear housing. Rotate the rear housing counter clockwise and remove it. *TOOLS: WHITE BLACK Insert the cable through the back of the rear housing GREEN Connect the wires according to the matching color. W/white = neutral, G/green = ground, Y/Red = line Tighten the screws to 30-35 In/Lb. Do not over tighten. Install the rear housing and tighten the screw. ( 3.0-3.9 In/Lb). *TOOLS: *TOOLS: *TOOLS: ( 4.5-5.5 In/Lb). 5/8" 1" Loosen the screws and remove the cable bushing, this may be needed later. *TOOLS: Make sure the wiring is tight and secured. Reposition your new SafeView Power Inlet over the hole and align the screw holes. Secure the power inlet to the RV with the four screws. ( 4.5-5.5 In/Lb). Verify proper installation. Make sure it is tight and secure. Press down the cover *TOOLS: RV MANUFACTURER INSTALLATION GUIDE 2.7" For Hipot Test-Make After Hipot Test-Make surethe screw is loose. sure the screw is tightened down. *TOOLS: (FOR HIPOT TEST ONLY!!!) Make a hole of 2.7" diameter in the place where the INLET is to be installed On the SafeView Power Inlet, loosen the screw on the rear housing. Rotate the rear housing counter clockwise and remove it. *TOOLS: WHITE BLACK Insert the cable through the back of the rear housing GREEN Connect the wires according to the matching color. W/white = neutral, G/green = ground, Y/Red = line Tighten the screws to 30-35 In/Lb. Do not over tighten. Install the rear housing and tighten the screw. ( 3.0-3.9 In/Lb). *TOOLS: *TOOLS: *TOOLS: ( 4.5-5.5 In/Lb). 5/8" 1" Loosen the screws and remove the cable bushing, this may be needed later. *TOOLS: Make sure the wiring is tight and secured. Reposition your new SafeView Power Inlet over the hole and align the screw holes. Secure the power inlet to the RV with the four screws. ( 4.5-5.5 In/Lb). Verify proper installation. Make sure it is tight and secure. Press down the cover *TOOLS:Corel PDF Engine Version 18.0.0.448 CorelDRAW X8