Strex Car Stereo 1-DIN

Introduction

You get the most out of your car ride with a good radio. Tune in to your favorite radio station or immediately switch to AUX or Bluetooth. Hands-free calling is now convenient thanks to the built-in microphone in the Strex car radio. Phone almost empty? No problem. You can always charge the phone thanks to the USB port.

Getting Started

The illustrations in this manual have been created with care. However, some parts of the product may differ from the illustration shown in this manual. Strex is not obliged to adjust the part or the manual in such cases. This manual is intended for the end user of the product.

Warning

⚠️ Improper use of this product and accessories is dangerous to you and others and can damage, destroy, or cause a serious accident. We therefore ask you to read the manual carefully and to strictly observe the danger, safety, and warning messages.

Installation and Connections

Operating Voltage: 12V DC

Frequency Range: FM 87.5~108.0MHz

Wiring Diagram Description:

The wiring plug and socket facilitate connections for audio output, power, and speakers. The wiring plug includes connections for Ground (Black), Memory Backup (Yellow), and Ignition Switch (Red). The wiring socket provides connections for audio outputs (Left Rear, Left Front, Right Front, Right Rear) and speaker connections (Left Front, Left Rear, Right Front, Right Rear) using specific wire colors (White, White/Black, Green, Green/Black, Grey, Grey/Black, Purple, Purple/Black). A Blue wire is designated for the Power Antenna. An Antenna Input Connector is also present.

Note: Specifications and design are subject to possible modification without notice due to improvement.

Specifications

FM Tuner

• Frequency Range: 87.5~108.0
• Sensitivity: 12dB μV
• I.F. Frequency: 10.7MHz
• Frequency Response: 40Hz~15KHz(±3dB)
• Stereo Separation: > 28dB
• S/N Ratio: > 50dB

General

• Power Supply Voltage: 12V DC, Negative Ground
• Max Current Consumption: 15A
• Max Output Power: 4x60W

Operation Manual

Location of Controls

The front panel features numerous controls for operation. A diagram illustrates these controls, numbered 1 through 20:

• 1. Power ON/OFF
• 2. Function Selector (radio/usb/sd/aux-in/bt) & End call
• 3. Auto Seek Search Tuning (AMS)
• 4. Band Button (FM1-FM2-FM3) & Answer call
• 5./6. Track Skip/ Search Forward/ Backward, Manual Auto Search Radio
• 7. Memory Station 1-6 for Radio and Play/pause Function for MP3/WMA
• 8. Intro Function for MP3/WMA
• 9. Repeat Function for MP3/WMA
• 10. Random Function for MP3/WMA
• 11. -10 Function for MP3/WMA
• 12. +10 Function for MP3/WMA
• 13. SD Card Slot
• 14. Aux In Jack
• 15. USB Port
• 16. LCD Display
• 17. Volume / Select Control
• 18. Reset Button
• 19. EQ Button
• 20. CLK Button

Bluetooth Pairing: Search for Bluetooth devices on your phone. Pair to the device using the password "0000". Some phones automatically connect to the radio after searching.

Operating Instructions

1. POWER ON/OFF: Short press to turn on, long press for three seconds to turn off.
2. MODE--FUNCTION SELECTOR: Push this button repeatedly to cycle through modes: RADIO → USB → SD → AUX-IN → BT. In Bluetooth mode, a short press ends the call.
3. AUTO SEEK SEARCH TUNING (AMS): In Radio Mode, short press to browse, long press to automatically save the station. In playback mode, this function selects the song.
4. BAND BUTTON: In radio mode, cycle through bands (FM1-FM2-FM3) by pressing this key.
5. 5./6. BUTTON: In MP3 player mode (usb/sd/mmc), skip tracks or search forward/backward. In radio mode, search for desired radio stations. Press during playback to go to the desired track.
6. 1/ BUTTON: Memory stations 1-6 for radio. Controls playback from USB or SD/MMC devices. Press once to start playback, press again to pause, and press once more to resume.
7. 2/INT BUTTON: When pressed, 'INT' is displayed, and the first few seconds of each track are played. Press again to stop the intro and listen to the full track.
8. 3/RPT BUTTON: When pressed, 'RPT' is displayed, and the selected track will repeat continuously until the repeat mode is cancelled by pressing the 'RPT' button again.
9. 4/RDM BUTTON: When pressed, 'RDM' is displayed, and tracks play in random order. Press the 'RDM' button again to cancel random mode.
10. 5/-10 BUTTON: In playback mode, short press to go back 10 songs; long press to choose a folder.
11. 6/+10 button: In playback mode, short press to skip forward 10 songs; long press to choose a folder.
12. SD CARD SLOT: Insert SD/MMC card gently. Select SD with the mode selector. Music plays automatically. Supports MP3, WMA formats.
13. AUX IN JACK: Connect your portable player using a 3.5mm cable. Audio will play through the car speaker.
14. USB PORT: Use a USB cable (not included) to connect your portable MP3 player or phone.
15. LCD DISPLAY: Shows current reception and function.
16. VOLUME / SELECT CONTROL: Rotate the volume knob to adjust volume. Short press the Select button to cycle through functions: volume (knob) → select (press down) → Bass → Treble Balance → Fader → Loudness → EQ (flat-pop-classic-rock).
17. RESET BUTTON: Restores factory defaults.
18. EQ & LOUD BUTTON: Adjusts EQ (flat-pop-classic-rock) and Loudness (ON/OFF).
19. CLK BUTTON: Electronic clock button. Long press for approximately 3 seconds to set the time.

FCC Warning

⚠️ FCC WARNING:

FCC ID: 2ABQZ-JSD

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Manual Information

All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher, except in the case of brief quotations embodied in critical reviews and certain other noncommercial uses permitted by copyright law. For permission requests at the address below.

Strex

SBD Trading B.V. (Strex Europe)
Noorwegenstraat 6-A4
7418BC Deventer
The Netherlands
info@strex.nl • www.strex.nl

© Strex 2021