the Toast & Melt™ Sandwich Press

Contents

• ? Breville Recommends Safety First
• ⚙️ Functions
• ? Tips
• ? Care & Cleaning

Breville Recommends Safety First

At Breville, safety is paramount. Breville designs and manufactures consumer products with the safety of its valued customers in mind. Users are asked to exercise a degree of care when using any electrical appliance and adhere to the following precautions.

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE

• Carefully read all instructions before operating the sandwich press for the first time and save for future reference.
• Remove and safely discard any packaging material and promotional stickers before using the sandwich press for the first time.
• To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the power plug of this appliance.
• Do not place the sandwich press near the edge of a bench or table during operation. Ensure that the surface is level, clean and free of water.
• Keep the sandwich press clear of walls, curtains and other heat or steam sensitive materials.
• The sandwich press must be used on a properly grounded outlet. If unsure about grounding, consult an electrician.
• Do not, under any circumstances, modify the power plug or use an adapter.
• Do not place the sandwich press on or near a hot gas or electric burner, or where it could touch a heated oven. Use the sandwich press well away from walls.
• Provide adequate space above and on all sides for air circulation around the sandwich press.
• Do not place the sandwich press on any surface that may be affected by heat. Use of a heat-resistant mat is recommended.
• Do not use on a sink drain board.
• Always use the sandwich press on a dry, level surface.
• Do not touch hot surfaces. Use the handles to lift and open the top plate. Take care when using the Adjustable Grilling Height Control.
• Do not leave the sandwich press unattended when in use.
• The outer housing may be hot during and after use. Do not touch hot surfaces. Keep the power cord and cords of nearby appliances clear from the housing.
• The sandwich press is not suitable for use in a small appliance enclosure. Ensure adequate space (minimum 10cm) all around.
• Do not place anything on top of the sandwich press when the lid is closed, in use, or stored.
• Always switch the sandwich press off at the power outlet, unplug the power cord, and allow to cool if not in use, before cleaning, moving, disassembling, assembling, or storing.
• Do not use harsh abrasives, caustic cleaners, or oven cleaners.
• Keep the exterior housing and non-stick cooking plates clean. Refer to Care, Cleaning and Storage (Page 9).

? NOTE: This appliance is not intended to be operated by means of an external timer or separate remote control system.

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

• Fully unwind the power cord before use.
• Connect only to a 230V or 240V power outlet.
• Do not let the power cord hang over the edge of a bench or table, touch hot surfaces, or become knotted.
• To protect against electric shock, do not immerse the power cord, power plug, or appliance in water or any other liquid, or allow moisture to contact parts unless recommended in cleaning instructions.
• Children should be supervised to ensure they do not play with the appliance.
• It is recommended to regularly inspect the appliance. To avoid a hazard, do not use if the power cord, plug, or appliance is damaged. Return to an authorised Breville Service Centre for examination and/or repair.
• The appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised or instructed by a person responsible for their safety.
• Any maintenance other than cleaning should be performed at an authorised Breville Service Centre.
• This appliance is for household use only. Do not use for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.

❗ IMPORTANT

• Fully unwind the power cord from the cord storage facility before use.
• The installation of a residual current device (safety switch) is recommended for additional safety protection. A safety switch with a rated residual operating current not exceeding 30mA should be installed in the electrical circuit supplying the appliance. Consult an electrician for professional advice.
• During electrical storms, disconnect the appliance from the power source at the wall socket to prevent damage from electrical surges.
• Always turn the appliance to the off position, switch off at the power outlet, and unplug when not in use.
• Before cleaning, turn the appliance to the off position, switch off at the power outlet, unplug, and remove the power cord (if detachable). Allow all parts to cool.
• Do not place this appliance on or near a heat source, such as a hot plate, oven, or heaters.
• Position the appliance at a minimum distance of 20cm away from walls, curtains, and other heat or steam sensitive materials. Provide adequate space above and on all sides for air circulation.

FOR HOUSEHOLD USE ONLY

SAVE THESE INSTRUCTIONS

Components

The Breville Toast & Melt Sandwich Press features:

• A. Power (BSG540 2200W / BSG520 2000W): For fast heat-up and quick toasting.
• B. Heavy duty die-cast arms: For durability and strength.
• C. Floating top plate: Automatically adjusts to thick or thin sandwiches.
• D. Flat non-stick cooking plates: For extra crispy toasted results.
• E. 'Power' and 'Ready' lights: Indicate when the sandwich press is heating or ready to use.
• F. Adjustable height control clip: With 4 settings for making open sandwich melts, toasted sandwiches, and everything in between.
• G. Safety locking storage clip: To lock plates closed for upright storage.
• H. Non-slip feet
• I. Convenient cord wrap in base

[Diagram: Image of the Breville sandwich press with labels A through I pointing to different parts.]

Functions

BEFORE FIRST USE

• Remove any promotional materials and packaging before use.
• Check that the cooking plates are clean and free of dust. If necessary, wipe with a damp cloth.
• A fine smoke haze may be noticed during the first use; this is caused by the heating of components and requires no concern.

TOASTED SANDWICH

1. Insert the power plug into a 230V or 240V power outlet and turn the power ON. The red 'POWER' light will illuminate.
2. Allow the sandwich press to pre-heat with the top plate closed until the green 'READY' light illuminates.
3. Prepare the sandwich while pre-heating. Once pre-heated, place the sandwich onto the bottom cooking plate, towards the rear.
4. Close the top cooking plate. The floating hinge ensures even pressing. (See Fig. 1)
5. Toasting typically takes 5-8 minutes, varying by taste, bread type, and filling.
6. When cooked, use the handle to open the press and raise the top plate. Remove the sandwich with a plastic or wooden spatula. Never use metal tongs or a knife, as they can damage the non-stick coating.

? NOTE:

• Always allow the sandwich press to pre-heat until the green 'READY' light illuminates.
• The safety locking storage clip should not be used to clamp the top plate down when sandwiches are inside. The top plate's weight will gradually press the sandwich.
• A fine smoke haze during the first use is normal and caused by component heating.

⚠️ CAUTION: HOT SURFACE - Accessible surfaces may be hot during and after operation.

Ensure the power cord is fully unwound before use.

The Adjustable Height Control allows the top plate to be positioned at various heights above the bottom plate. This enables use as an open toaster for melts or for toasting without applying top plate weight.

[Diagram: Fig. 1 showing the sandwich press closed.]

OPEN SANDWICH MELTS

1. Allow the sandwich press to pre-heat until the green 'READY' light illuminates.
2. Place the sandwich to be melted on the bottom plate.
3. Move the Adjustable Height Control clip on the right side to the desired height. (See Fig. 2)
4. Slowly lower the top plate until it rests on the clip.
5. The top plate will radiate heat to melt ingredients like cheese.
6. Toasting melts takes approximately 3-4 minutes, varying by taste and top plate height.

[Diagram: Fig. 2 showing the Adjustable Height Control clip and its settings.]

Adjustable Height Control: Toasts or melts any bread thickness in minutes. ↕️

? NOTE: The Adjustable Height Control can be moved to accommodate thick or thin melts by sliding the clip forwards or backwards along the arm.

Tips

BREAD

Most bread types are suitable: white, wholemeal, kibbled wheat, wholegrain, raisin loaf, etc. The press is ideal for foccacia, Turkish bread, baguettes, and bread rolls. Sweet breads with high sugar content (e.g., raisin bread, brioche) may brown quicker.

FILLINGS

Use canned or pre-cooked fruit to avoid excessive juices from fresh fruit. Be cautious when eating sandwiches with fillings like cheese, tomato, or jam, as they retain heat and can cause burns if consumed too quickly.

TOASTING BREAD

The flat plate design is excellent for toasting plain breads and Turkish bread without fillings or spreads. Toasting Turkish bread with jam offers a tasty breakfast alternative.

FAT FREE SNACKS

Due to the non-stick plate design, butter or margarine is not required on the outside of snacks.

[Diagram: Fig. 3 showing the sandwich press with the top plate slightly open.]

Care & Cleaning

Before cleaning, switch off at the power outlet and remove the plug. Allow the sandwich press to cool; it is easier to clean when slightly warm.

Clean after each use to prevent baked-on food buildup. Wipe cooking plates with a soft cloth. For stubborn food, reheat the unit for 1-2 minutes, brush with a little oil or melted butter, let stand for five minutes, then wipe with a damp cloth.

? NOTE:

• The cooking plates have a non-stick surface; do not use abrasives.
• Do not use spray-on non-stick coatings, as this will affect the performance of the plates.

STORAGE

1. Switch off at the power outlet and unplug the power cord.
2. Allow the sandwich press to cool completely.
3. Slide the Adjustable Height Control towards the front handle to the 'LOCK' position to secure the top and bottom cooking plates together. (See Fig. 4)
4. Wrap the power cord in the cord storage area below the appliance. (See Fig. 5)
5. Store on a flat, dry, level surface.

? NOTE: The storage clip should not be used to clamp the top plate down when sandwiches are in the press.

⚠️ WARNING: Do not immerse any part of the sandwich press in water or any other liquid.

[Diagram: Fig. 4 showing the locking mechanism.]

[Diagram: Fig. 5 showing the cord wrap.]

Breville Customer Service Centre

Australian Customers
Phone: 1300 139 798
Web: www.breville.com

New Zealand Customers
Phone: 0800 273 845
Web: www.breville.com

Breville, the Breville logo, Master Every Moment, and the Toast & Melt are registered trademarks of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2019.

Due to continued product improvement, the products illustrated/photographed in this brochure may vary slightly from the actual product.

Model: BSG520/BSG540 ANZ – G19