Anker PowerCore+ 26800 PD 45W User Manual

Product Overview

This document is the user manual for the Anker PowerCore+ 26800 PD 45W portable charger.

The PowerCore+ features multiple USB-A and USB-C ports for charging various devices. It supports Power Delivery (PD) for fast charging.

Key Features:

• Multiple USB-A and USB-C output ports
• Power Delivery (PD) input and output
• LED indicators to show charge level

Charging the PowerCore+

Connect the PowerCore+ to a power source using a compatible USB-C cable. The LED indicators will show the charging progress. When fully charged, the LED indicators will turn off.

Note: Simultaneous charging and recharging is not supported.

Specifications

Important Safety Instructions

When using this product, basic precautions should always be followed, including:

• Store product in a cool and dry place.
• Do not store the product in hot or humid environments.
• Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
• Operating temperature should be between 32°F to 104°F / 0°C to 40°C.
• Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
• If the product is not used for long periods of time, charge and discharge it once every three months.
• When charging a device, the product may feel warm; this is a normal operating condition and should not be cause for concern.
• In normal conditions, battery performance will decline over several years.
• Do not dispose of the product in heat or fire.
• Do not clean the product with harmful chemicals or detergents.
• Misuse, dropping, or excessive force may cause product damage.
• When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
• Discharged batteries may cause fire or smoke; tape the terminals to insulate them.
• Do not disassemble, open, crush, puncture, or incinerate the power bank.
• Do not expose the power bank to heat sources or fire, or store it in direct sunlight.
• Do not short-circuit the power bank.
• Do not subject the power bank to mechanical shock.
• If leakage occurs, do not allow the liquid to come into contact with skin or eyes. If contact occurs, rinse the affected area with plenty of water and seek medical attention.
• Charge the power bank only according to the manufacturer's instructions.
• Keep the power bank clean and dry.
• Do not overcharge the power bank.
• Keep the original manual for future reference.
• Dispose of used power banks in accordance with national environmental regulations.
• Rechargeable batteries may cause fire or smoke; tape the terminals to insulate them before disposal.
• Do not expose batteries to high heat such as sunlight, fire, or the like.
• Incorrect replacement may result in an explosion. Replace only with the same or equivalent type.
• Do not expose the battery or battery pack to high heat such as sunlight, fire, or the like.
• Do not dispose of batteries in household waste; dispose of them at designated recycling points.

Regulatory Information

Declaration of Conformity: Anker Innovations Limited declares that product type A1376 is in compliance with Directive 2014/30/EU. The full text of the EU declaration of conformity is available at: https://www.anker.com

FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

To prevent harmful radio interference, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.

Importer: Fantasia Trading LLC, 9155 Archibald Avenue, Suite 202, Rancho Cucamonga, CA, 91730, US. Telephone: +1 (909) 484 1530

IC Statement: This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

This symbol indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

Customer Service

Warranty: 18-month limited warranty*

Technical Support: Lifetime technical support

Contact:

• Email: support@anker.com
• US: +1 (800) 988 7973 (Mon-Fri 9:00am - 5:00pm PT)
• UK: +44 (0) 1604 936200 (Mon-Fri 6:00 - 11:00 GMT)
• DE: +49 (0) 69 9579 7960 (Mo-Fr 6:00 - 11:00)
• JP: +81 0344557823 (Mon-Fri 9:00 - 17:00)
• CN: +86 4000550036 (Mon-Fri 9:00 - 17:30)

*Note: Your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty.