Lithium Electric Reciprocating Saw

Important Warnings

Warning: Do not saw asbestos-containing materials.

1. Wear goggles when cutting materials that produce large amounts of flying debris.
2. Wear a protective mask when sawing fibre materials.
3. Remove the adjusting tool and wrench before starting the machine.
4. Fix the workpiece with a rack.
5. Only when the machine is turned on can the machine be moved to the workpiece.
6. Hold the machine with both hands at all times and make sure that you are in a safe and secure place while working.
7. The machine can be operated only after gaskets are assembled. In machine sawing, the pad must always be fixed on the workpiece.
8. The wrong operation may damage the machine. Therefore, the instructions must be followed at all times.
9. Only sharp blades can be used in perfect condition; broken, bent or blunt blades should be replaced immediately.
10. The machine should be opened after the saw blades have been installed.
11. Choose appropriate tools, impulses and swing movements according to the material. Mainly maintain a constant rate of elasticity.
12. Do not attempt to stop the saw blade with lateral pressure after the machine is closed.
13. Only genuine accessories can be used.

Image Description

A line drawing depicts a cordless reciprocating saw. It features a battery pack at the base and a saw blade extending from the front, designed for cutting wood and metal.

Warm Tips for Sawing

1. Adjust the blade and stroke rate to suit the material being processed. For right radius curves, a narrow saw blade is preferable. When sawing metal, use coolant and lubricant, and swing along the cutting line.
2. If necessary, check and remove foreign nails and screws from wood, particle-board, and building materials before sawing.
3. Secure the material properly and do not support the workpiece with your hands or feet. Avoid contact with moving parts or floors while the saw is running, as there is a risk of rebound.
4. Place the pad on the workpiece and apply constant pressure as you pass through it. If the saw blade becomes stuck, immediately shut down the machine. Use appropriate tools to widen the gap, then carefully pull out the saw blade. After finishing work, close the machine and set it down only after it has completely stopped running.