DOD FX51 Juice Box Overdrive

Important Notes

• The FX51 battery is in use whenever the INPUT jack is plugged in. Unplug the cable from the INPUT jack when not in use to prevent unnecessary battery drain.
• Remove the battery when the unit will not be used for an extended period to prevent potential damage from leaking battery fluids.
• If the FX51 fails to switch or the LED indicator remains lit, the battery needs immediate replacement.
• Using any AC adapter other than the DOD PS200R will void the product warranty.
• Unauthorized repair of the FX51 will void the warranty. Contact your DOD FX pedal dealer for return/repair information if service is required.

DOD Warranty

1. The warranty registration card must be mailed within ten days after the purchase date to validate the warranty.
2. DOD warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.
3. DOD's liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer. All parts and labor will be covered for up to three years. DOD shall not be liable for any consequential damage resulting from the product's use in any circuit or assembly.
4. Proof-of-purchase is the responsibility of the consumer.
5. DOD reserves the right to make changes in design or additions or improvements to this product without incurring any obligation to install the same on previously manufactured products.
6. This warranty is in lieu of all other warranties, expressed or implied. DOD neither assumes nor authorizes any person to assume for it any obligation or liability in connection with the sale of this product. In no event shall DOD or its dealers be liable for special or consequential damages or for any delay in performance of this warranty due to causes beyond their control.

Product Description

The FX51 is an overdrive pedal designed to work with or without an already distorted amplifier. It provides a "squishy" tube sound, suitable for blues to rock and roll music. The pedal can add character and "Juice" to a distorted amplifier without becoming harsh, enhancing harmonics and allowing for a wide range of tones.

Connecting the FX51

Connect your guitar to the input of the FX51. Connect the output of the FX51 to your amplifier or another effects device. To use AC power and eliminate the need for a 9-volt battery, attach the DOD PS200R to the AC adapter jack.

Features

• LED indicator shows effect status and battery condition.
• Active switching for noiseless operation.
• Easy access battery compartment.
• Adapter jack for AC operation.
• Rugged die-cast metal case.
• Three year limited warranty.
• Rubber non-skid bottom.

Controls

• SWEET: Controls the amount of distortion added to a guitar when it is already running into a distorted amplifier. Use this control to overdrive the front end of amplifiers and add a solo boost.
• PULP: Controls the low frequency EQ of the FX51. Use this control to adjust the amplifier's distortion sound from thin to flubby.
• TANG: Controls the amount of high frequency EQ of the FX51. Use this control to make your amplifier sound crisp or to add harmonics that can cause the guitar to oscillate.
• JUICE: Adds gain or distortion to the FX51. Turning this up while using a distorted amp increases the sustain of the notes.
• FOOTSWITCH: Switches the effect in or out of the signal path.
• LED INDICATOR: Lights when the distortion is enabled; it is not lit when the distortion is bypassed.
• JACKS: Input, Output, AC Adapter (use the DOD PS200R power supply only).

Setting Up the Effect

When setting up the effect, use the SWEET control to match the level of the distortion effect with the level of the original input signal. The control should be set for a slight increase in level when the effect is switched into the signal path. When using the FX51 with a distorted amplifier, use it to control how hard the signal "hits" the front of the amp or distorts it. The more it is turned up, the more the amp will distort.

The following examples show different sound settings with graphic representations of knob positions. Use these as starting points to create your own sounds.

Rock Overdrive

This setting provides a rock or slightly over-driven ska sound. Use a good hollow body guitar. Set SWEET to 12 o'clock, PULP to 2 o'clock, TANG to 12 o'clock, and JUICE to 12 o'clock.

Settings: SWEET: 12:00, PULP: 2:00, TANG: 12:00, JUICE: 12:00

Punk Distortion

To achieve a punk sound, first adjust your amp for a medium gain distortion setting. Then, use the FX51 with SWEET turned up (usually all the way), PULP to 12 o'clock, TANG turned up, and JUICE all the way up.

Settings: SWEET: Max, PULP: 12:00, TANG: Max, JUICE: Max

Metal Solo

For a standard metal solo sound, use the FX51 alone. Set PULP to 2 o'clock, TANG to 12 o'clock, and JUICE up. This setting is suitable for fast playing and includes pick squeals.

Settings: PULP: 2:00, TANG: 12:00, JUICE: Max

Solo Boost

To change the tone and gain of your amp for solos, set your amp for a good distortion setting. Then, set the FX51's SWEET control up, PULP to 9 o'clock, TANG to 9 o'clock, and JUICE up. Use the FX51 when soloing or for feedback.

Settings: SWEET: Max, PULP: 9:00, TANG: 9:00, JUICE: Max

Contact Information

DOD Electronics Corporation
8760 South Sandy Parkway
Sandy, Utah 84070
Telephone: (801) 566-8800
FAX: (801) 566-7005

International Distribution
3 Overlook Drive Unit 4
Amherst, New Hampshire 03031
U.S.A.
FAX: (603) 672-4246

Copyright © 1996 DOD Electronics Corporation. Printed in U.S.A. 4/96. Manufactured in the U.S.A. FX51 18-2136-B