Niceboy RAZE 3 RADION Bluetooth Speaker User Manual
Package Contents
- Bluetooth speaker
- Micro USB charging cable
- Audio cable
- Instructions for Use
Product Description
The Niceboy RAZE 3 RADION speaker features the following buttons and ports:
- Buttons:
- 1: Turn down volume / Previous track
- 2: Turn up volume / Next track
- 3: LED indicator
- 4: Power on/off
- 5: Change modes
- 6: Playback / Pause / Call accept / Call decline / Hang up / Last called number
- Ports:
- 7: AUX port 3.5 mm jack
- 8: USB charging - output, input for USB flash disk
- 9: SD card slot
- 10: Micro USB charging port
Charging
For optimal battery life, fully charge the speaker before first use. Charging takes approximately 5 hours. A low battery is indicated by an audible signal. Connect the included micro USB cable to the charging port (10) and a 5V/1A adapter or PC USB port. Charging progress is shown by 2 LED diodes (3); both LEDs turn off when fully charged.
Powering On/Off
Press and hold the power button (4) for 3 seconds. Powering on and off is confirmed by an audio signal.
Connecting to Bluetooth
- Upon powering on, the speaker enters Bluetooth pairing mode, indicated by blue flashing LED diodes (3).
- Activate Bluetooth on your device and select "Niceboy RAZE 3 radion" from the list of available devices.
- Your device will connect to the speaker. Successful pairing is confirmed by an audio signal and LED diodes (3) flashing every 5 seconds.
*The speaker will automatically connect to the last paired device upon subsequent power-on.
Playback
Press button (6) briefly to play or pause tracks. Adjust volume by pressing and holding buttons (1) and (2). Press and hold button (2) to skip to the next track, and button (1) to skip to the previous track.
AUX Mode
- Insert the included 3.5 mm jack cable into the audio port (7). The speaker will automatically switch to AUX mode.
- Use your connected device to control music playback.
Volume can be adjusted by long-pressing buttons (1) and (2). Playback or pause is controlled by a short press of button (6).
FM Mode
Connect the micro USB cable to the charging port (10) to use it as an antenna. Press button (5) briefly to enter FM mode (indicated by an audio signal). Press and hold button (6) to search for and save radio stations. Press and hold button (6) again to stop the automatic search. After the search, switch between stations by briefly pressing buttons (1) and (2). Playback or pause is controlled by a short press of button (6).
Micro SD Card, USB Flash Disk
Insert an SD card or USB flash disk. The speaker will automatically switch to the appropriate mode. Playback or pause is controlled by a short press of button (6). Adjust volume by long-pressing buttons (1) and (2). Briefly press the same buttons to skip to the next or previous track.
Telephone Calls
Press button (6) to accept and end telephone calls. Incoming calls can be declined on your device. Double-press button (6) to redial the last called number.
True Wireless (TWS) Connection
Connect two Niceboy RAZE 3 radion speakers to play music simultaneously.
- Power on both speakers and ensure they are not connected to any other Bluetooth device.
- Long-press button (5) on one of the speakers. A successful connection is indicated by an audio signal.
- Open your device's Bluetooth settings and select "Niceboy RAZE 3 radion". Successful pairing is confirmed by an audio signal.
Parameters
- Bluetooth version: 5.0
- Supported codecs: SBC, A2DP, AVRCP, HFP
- Power: 24W
- Impedance: 8Ω
- Sensitivity: >75dB
- Frequency range: 65 Hz - 20 kHz
- Bluetooth transmission distance: 10 meters
- FM frequency: 87.5MHz ~ 108MHz
- Supported data carriers: micro SD card, USB flash disk, max. 32GB
- Supported audio formats: MP3, WMA, WAV, APE, FLAC
- Battery: Li-Ion 5000 mAh
- Battery life: 24 hours (at 50% volume)
- Watertightness: IP67
This product meets all basic EU regulation requirements.
