Jetson Strike All-Terrain Hoverboard

Remember to be safe and most importantly, have fun!

What's in the Box

• 1. Front LED Lights
• 2. Charging Port
• 3. Power Button
• 4. Charger

Please fully charge the battery prior to use.

Specs & Features

• Weight Limit: 220 lb
• Product Weight: 16 lb
• Product Dimensions: 23.5" x 7" x 7"
• Recommended Age: 12+
• Tire Size: 6.5" All-Terrain Tires
• Max Speed: Up To 9 mph
• Max Range: Up To 10 Miles
• Battery: 36V, 2.0Ah Lithium-Ion
• Motor: 400W, Dual Hub Motor
• Charger: UL LISTED, 100-130V
• Charge Time: Up To 3 Hours
• Climbing Angle: Up To 15°

1. Get Started

1.1 Charging the Battery

• Only use the included charger.
• Plug the charger into the wall before connecting to the Charging Port.
• Do not turn on the Strike while it's charging.
• Charge the battery until it is fully charged – up to 3 hours.
• Replace the cover over the Charging Port when done.

Charging Status: The indicator light on the charger shows charging status. A full charge is indicated when the light turns green.

Diagram Description: A visual representation of the charger with an indicator light, showing states for 'Charging' and 'Charge Complete'.

1.2 Indicator Lights

The Strike features indicator lights to show its status:

• Status Indicator Light: Located on the hoverboard.
• Battery Indicator Light: Also on the hoverboard, shows remaining battery percentage.

Battery Indicator Light Colors:

• Red: Less than 20% battery.
• Yellow: 20% - 49% battery.
• Green: 50% or more battery.

Warning: The Strike will automatically turn off once the battery power goes below 10% as a safety precaution.

Status Indicator Light: If the Status Indicator Light turns red, or if you are experiencing issues with the Strike, you may need to recalibrate it.

1.3 How to Recalibrate

Follow these 3 simple steps:

1. Place the Strike on a flat, level surface.
2. Hold the Power Button (for about 5 seconds) until you are notified of a successful recalibration.
3. Restart the Strike by turning it off and then on.

Adults must assist children in the initial adjustment procedures of the product.

Diagram Description: An illustration showing a hand pressing and holding the power button on the hoverboard for approximately 5 seconds.

1.4 How to Change Speed

The Strike has three speed settings, each indicated by a different color:

• Green: Beginner (slow) mode
• Yellow: Intermediate (medium) mode
• Red: Advanced (fast) mode

Please Note: The default setting is advanced (fast) mode.

Follow these 3 simple steps to choose your mode:

1. Place the Strike on its side.
2. Power the Strike on – the indicator light will illuminate red for advanced (fast) mode.
3. Quickly press and release the power button to cycle through the speed modes. Stop once the indicator light changes to the respective color of your desired speed.

Please Note: When you turn off the Strike, it will return to the original factory setting – advanced (fast) mode.

2. Make Moves

2.1 Riding the Strike

Movement Controls:

• NEUTRAL: Both footpads are level.
• TURN LEFT: Lean your left foot forward and right foot back slightly.
• TURN RIGHT: Lean your right foot forward and left foot back slightly.
• FORWARD: Lean both feet forward.
• BACKWARD/STOP: Lean both feet backward.

Diagram Description: Visuals showing the hoverboard in a neutral position, and then tilting to indicate turning left and turning right.

Please Note: Images may not reflect exact appearance of actual product.

Care & Maintenance

RIDING RANGE

The maximum range is 10 miles. However, many factors will affect how far you can go per charge:

• Driving Surface: A smooth, flat surface will increase driving distance.
• Weight: More weight means less distance.
• Temperature: Ride, store, and charge the Strike above 50°F (10°C).
• Maintenance: Timely battery charging will increase driving distance.
• Driving Style: Frequent starting and stopping will reduce driving distance.

CLEANING THE STRIKE

To clean the Strike, carefully wipe with a damp cloth, then dry with a dry cloth. Do not use water to clean the Strike, as the electrical and electronic systems may get wet, resulting in personal injury or malfunction of the Strike. If the electric parts or battery get wet, do not power on the Strike. Please contact Jetson Customer Support for assistance.

BATTERY

• Keep away from fire and excessive heat.
• Avoid intense physical shock, severe vibration, or impact.
• Protect from water or moisture.
• Do not disassemble the Strike or its battery.
• Contact Jetson Customer Support if there are any issues with the battery.

STORAGE

• Fully charge the battery before storing. The battery should be fully charged once a month thereafter.
• Cover the Strike to protect against dust.
• Store the Strike indoors, in a dry place.

MODIFICATIONS

Do not attempt to disassemble, modify, repair, or replace the product or any components of the unit without instruction from Jetson Customer Support. This will void any warranty and can lead to malfunctions which may cause injury.

ADDITIONAL OPERATION CAUTIONS

• Do not lift the product off the ground while it is on and the wheels are in motion. This can result in freely spinning wheels, which may cause injury to yourself or others nearby.
• Do not jump on or off the product, and do not jump while using it.
• Always keep your feet firmly planted on the mat sensors while in operation.
• Always check the battery charge before using.

DISPOSAL OF USED BATTERY

Batteries may contain hazardous substances that could endanger the environment and human health. The symbol ⚠️ marked on the battery and/or packaging indicates that used batteries shall not be treated as municipal waste. Batteries should be disposed of at an appropriate collection point for recycling. By ensuring the used batteries are disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The recycling of materials will help conserve natural resources. For more information about recycling of used batteries, please contact your local municipality waste disposal service.

Safety Warnings

Before use, please read the user manual and safety warnings carefully, and make sure you understand and accept all the safety instructions. The user will be responsible for any loss or damage caused by improper use.

Before each cycle of operation, the operator shall perform the preoperation checks specified by the manufacturer:

• Ensure all guards and pads originally supplied by the manufacturer are in proper place and serviceable condition.
• Verify the braking system is functioning properly.
• Confirm any axle guards, chain guards, or other covers/guards supplied by the manufacturer are in place and serviceable.
• Check that tires are in good condition, inflated properly, and have sufficient tread remaining.
• Ensure the area where the product is to be operated is safe and suitable for safe operation.

Components shall be maintained and repaired in accordance with the manufacturer's specifications and using only the manufacturer's authorized replacement parts, with installation performed by dealers or other skilled persons.

• Warning against recharging non-rechargeable batteries.
• Do not allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drive train while the motor is running.
• This product should not be used by children or persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction (IEC 60335-1/A2:2006).
• Unsupervised children should not play with the product (IEC 60335-1/A2:2006).
• Adult supervision is required.
• The rider should not exceed 220 lb.
• Units shall not be operated to perform racing, stunt riding, or other maneuvers that may cause loss of control or uncontrolled operator/passenger actions or reactions.
• Never use near motor vehicles.
• Avoid sharp bumps, drainage grates, and sudden surface changes, as the hoverboard may suddenly stop.
• Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.
• Avoid riding around flammable gas, steam, liquid, or dust that could cause fire.
• Operators shall adhere to all manufacturer recommendations and instructions, and comply with all laws and ordinances. Units without headlights shall be operated only with adequate daylight conditions of visibility. Owners are encouraged to highlight their unit for conspicuity using lighting, reflectors, and for low-riding units, signal flags on flexible poles.
• Persons with the following conditions shall be cautioned not to operate: Those with heart conditions; Pregnant women; Persons with head, back, or neck ailments, or prior surgeries to those areas; and persons with any mental or physical conditions that may make them susceptible to injury or impair their physical dexterity or mental capabilities to recognize, understand, and perform all safety instructions, and to be able to assume the hazards inherent in unit use.
• Do not ride at night.
• Do not ride after drinking or taking prescription medication.
• Do not carry items when riding.
• Never operate the product barefooted.
• Always wear shoes and keep shoelaces tied.
• Make sure your feet are always placed securely on the deck.
• Operators shall always use appropriate protective clothing, including but not limited to a helmet with appropriate certification, and any other equipment recommended by the manufacturer. Always wear protective equipment such as a helmet, knee pads, and elbow pads.
• Always give way to pedestrians.
• Be alert to things in front and far away from you.
• Do not allow distractions when riding, such as answering the phone or engaging in any other activities.
• The product cannot be ridden by more than one person.
• When riding with other riders, always keep a safe distance to avoid a collision.
• When turning, be sure to maintain your balance.
• Riding with improperly adjusted brakes is dangerous and can result in serious injury or death.
• The brake may become hot while operating; do not touch the brake with your bare skin.
• Applying brakes too hard or too suddenly can lock up a wheel, which could cause you to lose control and fall. Sudden or excessive application of the brake may result in injury or death.
• If the brake loosens, please adjust with the hexagon wrench, or please contact Jetson Customer Support.
• Replace worn or broken parts immediately.
• Check whether all safety labels are in place and understood before riding.
• The owner shall allow the use and operation of the unit only after a demonstration that such operators can understand and operate all components of the unit before use.
• Do not ride without proper training. Do not ride at high speeds, on uneven terrain, or on slopes. Do not perform stunts or turn abruptly.
• Recommended for indoor use.
• Prolonged exposure to UV rays, rain, and the elements may damage the enclosure materials; store indoors when not in use.

California Proposition 65

▲ WARNING: This product can expose you to a chemical such as Cadmium that is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov/product.

NOTICE OF COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

Enjoying the ride?

Leave a review on ridejetson.com/reviews or share your photos with us online using the #RideJetson hashtag!

Questions? Let us know.

Support: support.ridejetson.com

Hours of Operation: 7 Days a Week, 10am-6pm

US: 1-(888) 976-9904 | UK: +44 (0)33 0838 2551

Website: www.ridejetson.com

Follow us

@ridejetson [f] [in]

#MakeMoves

Imported by Jetson Electric Bikes LLC.
86 34th Street 4th Floor, Brooklyn NY 11232

Date Code: 08/2020
Made in China

Certifications: CE, FC, UL LISTED