Jetson Aero All-Terrain Hoverboard

1.1 Charging the Battery

• Only use the included charger.
• Plug the charger into the wall before connecting to the Charging Port.
• Do not turn on the Aero while it is charging.
• Charge the battery until it is fully charged, which takes up to 3 hours.

Diagram description: Shows the charging port with an indicator light. The light is red when charging and turns green when charging is complete.

1.2 Indicator Lights

Status Light: If there is an issue with the Aero, the light will turn red, indicating a need for recalibration.

Battery Indicator Light: The light flashes red when the battery level falls below 20%. The Aero will automatically turn off once the battery power goes below 10% as a safety precaution.

1.3 How to Recalibrate

To recalibrate, hold the power button for approximately 5 seconds.

Follow these 3 simple steps:

1. Place the Aero on a flat, level surface.
2. Hold the Power Button (for about 5 seconds) until you are notified of a successful recalibration.
3. Restart the Aero by turning it off and then on.

Diagram description: Illustrates the hoverboard placed on a flat surface, with an instruction to hold the power button for 5 seconds.

Note: Adults must assist children in the initial adjustment procedures of the product.

2.1 Riding the Aero

NEUTRAL: The hoverboard is in a stable, level position.

TURN LEFT: To turn left, lean your body slightly to the left. The hoverboard will tilt accordingly. [Leftward tilt arrow]

TURN RIGHT: To turn right, lean your body slightly to the right. The hoverboard will tilt accordingly. [Rightward tilt arrow]

Diagram description: Shows the hoverboard in three positions: NEUTRAL (level), TURN LEFT (left side down), and TURN RIGHT (right side down), with arrows indicating the direction of turn.

Riding Range

The maximum range is 7 miles. Factors affecting range include:

• Driving Surface: A smooth, flat surface increases driving distance.
• Weight: More weight means less distance.
• Temperature: Ride, store, and charge the Aero above 50°F (10°C).
• Maintenance: Timely battery charging increases driving distance.
• Driving Style: Frequent starting and stopping reduces driving distance.

Cleaning the Aero

Carefully wipe with a damp cloth, then dry with a dry cloth. Do not use water to clean the Aero, as electrical and electronic systems may get wet, potentially causing injury or malfunction. If electric parts or the battery get wet, do not power on the Aero. Contact Jetson Customer Support for assistance.

Battery

• Keep away from fire and excessive heat.
• Avoid intense physical shock, severe vibration, or impact.
• Protect from water or moisture.
• Do not disassemble the Aero or its battery.
• Contact Jetson Customer Support US 1-(888) 976-9904 for any battery issues.

Storage

• Fully charge the battery before storing.
• Recharge the battery once a month after initial storage.
• Cover the Aero to protect against dust.
• Store the Aero indoors, in a dry place.

Modifications

Do not attempt to disassemble, modify, repair, or replace the product or its components without instruction from Jetson Customer Support. This will void any warranty and may lead to malfunctions causing injury.

Additional Operation Cautions

• Do not lift the product off the ground while it is on and the wheels are in motion. This can result in freely spinning wheels, which may cause injury.
• Do not jump on or off the product, and do not jump while using it.
• Always keep your feet firmly planted on the mat sensors while in operation.
• Always check the battery charge before using.

Disposal of Used Battery

Batteries may contain hazardous substances. This symbol [Recycling Symbol] indicates that used batteries should not be treated as municipal waste. Dispose of batteries at an appropriate collection point for recycling to prevent negative consequences for the environment and human health. Recycling conserves natural resources. For more information, contact your local municipality waste disposal service.

California Proposition 65

WARNING: This product can expose you to a chemical such as Cadmium, which is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov/product.

Notice of Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.