Easy as 1-2-3 Assembly Instruction

Step 1

Attach the two side rails (B) and the center support (C) to the headboard (A). The diagram shows two support pieces (O) being secured to the headboard (A) using screws (S), and then the side rails (B) are attached to these support pieces (O).

Parts used: A, B (x2), C, O (x1), S (x2)

Step 2

Attach the footboard (D) to the other ends of the side rails (B). Secure using screws (S).

Parts used: B, D, S (x2)

Step 3

Position the support beams (H). The diagram shows the support beams being unfolded or rotated into place.

Parts used: H (x1)

Step 4

Attach the support beams (H) to the headboard (A) and footboard (D). Secure using screws (S). The diagram shows screws being inserted into pre-drilled holes.

Parts used: A, D, H, S (x2)

Step 5

Attach the two center support rails (I) to the inside of the side rails (B). Secure using screws (S).

Parts used: B, I (x2), S (x2)

Step 6

Place the wooden slats (K) across the support beams (H) and center support rails (I) to form the mattress base.

Parts used: H, I, K (x2 sets)

Step 7

Attach the legs (E) to the designated points on the frame, typically at the corners of the footboard and side rails. The diagram shows legs being attached.

Parts used: B, D, E (x2)

Step 8

The diagram shows the fully assembled bed frame.

Step 9

Connect the side rails (labeled 'D' in the diagram) to the headboard (A) using bolts (J). The diagram also shows the crossbar (F) being attached to the headboard.

Parts used (referencing component list): Headboard (A), Side Rails (B, labeled as D in diagram), Crossbar (F), Bolts (J, x2)

Step 10

The diagram shows the assembled frame with the headboard (A), side rails (labeled 'D' in diagram), and crossbar (F) connected. The support beam (H) is also shown.

Parts used (referencing component list): Headboard (A), Side Rails (B, labeled as D in diagram), Crossbar (F), Support Beam (H)

Step 11

Connect the side rails (labeled 'D' in the diagram) to the footboard (D) using bolts (J). The diagram also shows the crossbar (F) being attached to the footboard.

Parts used (referencing component list): Side Rails (B, labeled as D in diagram), Footboard (D), Crossbar (F), Bolts (J, x2)

Step 12

Attach the center support rails (I) to the side rails (labeled 'D' in the diagram) using bolts (J).

Parts used (referencing component list): Side Rails (B, labeled as D in diagram), Center Support Rails (I, x2), Bolts (J, x2)

Step 13

Place the wooden slats (K) onto the frame, resting on the side rails and center support rails.

Parts used: K (x2 sets)

Step 14

The diagram shows the fully assembled bed frame with the wooden slats in place.