Full Factory Reset for Bluetooth Connection

Instructions:

1. Remove Existing Connection:
   1. Go to your device's Bluetooth Settings → Connections.
   2. Remove "ScanAvenger HID" from the list.
2. Scan the Barcodes Below in Order:
   • No need to print these codes; they can be scanned from the screen.
   • The scanner may not make sounds or vibrate while scanning certain codes; this is normal behavior.

   Step 1: [Barcode Image Placeholder - Code93]

   Step 2: [QR Code Placeholder - SpecCode93]

   Step 3: [QR Code Placeholder - SpecCode79]

   Step 4: [QR Code Placeholder - SpecCode77]

   Step 5: [QR Code Placeholder - SpecCode35]

   Step 6: [QR Code Placeholder - SpecCode95]

   Step 7: [QR Code Placeholder - SpecCode7B]

   Step 8: [QR Code Placeholder - SpecCode9C]

   Step 9: [QR Code Placeholder]

   Step 10: [QR Code Placeholder]

   Step 11: [QR Code Placeholder - SpecCode92]

   Step 12: [QR Code Placeholder]

   Step 13: [QR Code Placeholder]

3. Pair the Scanner:
   1. The scanner light should start flashing blue, indicating it's ready to pair.
   2. Go to Bluetooth Settings and select "ScanAvengerHID" to pair. If it doesn't appear, refresh the Bluetooth search.
   3. A solid blue light on the scanner confirms a successful connection.