CARE AND MAINTENANCE MANUAL
ALWAYS
- Clean every day by thoroughly rinsing with mild soap and warm water and wipe dry with a cloth.
- Keep the tub free of any standing water as this can cause a buildup of mineral deposit, which can affect the appearance of your sink.
- Always rinse the bathtub after using any cleaning agent and wipe dry with a cloth. Clean any mineral deposits built up over time with a mild solution of vinegar and water followed by thorough flushing with water.
NEVER
- Use steel wool or a scouring pad as it damages the sink surface and causes discoloration.
- Let household cleaning agents or bleach sit in your bathtub for a long period as this may ruin the finish of your sink.
- Leave rubber mats, sponges, or cleaning pads in the bathtub for long periods as this may damage the finish of your tub.
- Use the inside of the tub as a cutting surface.
NOTE
The uneven surface --- To finish polishing a bathtub, Clovis usually applies wax to make it shine and protect it from stains and scratches. However, the extra wax will eventually generate an uneven surface. Before using it, please use a clean cloth with warm water in circular motions to lightly wipe the surface to remove the extra wax.
The water stain --- To finish testing the bathtub overflow, Clovis usually inspects the bathtub overflow drains by running water down the drains to test if there is any leak at the overflow. Therefore, water stains may be found on the surface of the bathtub.
