ZOTAC ZBOX C Series Nano: Quick Start Guide

Introduction

This guide provides essential information for setting up your ZOTAC ZBOX C Series Nano. It covers the package contents, how to customize your device, and step-by-step instructions for installing memory modules and a hard disk drive.

Package Contents

• ZOTAC ZBOX nano
• ZOTAC VESA mount
• AC adapter
• Power cord
• WiFi antenna
• Quick Start Guide
• OS Recovery USB Drive (Optional)

Getting Started

Customizing Your ZOTAC ZBOX NANO

1. Loosen and remove the 4 thumb screws securing the bottom cover.
2. Gently remove the cover.

Installing Memory Modules

1. Locate the SO-DIMM memory slots and insert a SO-DIMM memory module into the slot at a 45-degree angle.
2. Gently press down on the memory module until it locks into place by the arms of the memory slot.

Installing a Hard Disk

1. Locate the hard disk bracket, remove the screw, and remove the hard disk bracket.
2. Install the hard disk bracket to a 2.5-inch SATA hard disk/SSD with 2 screws.
3. Insert the hard disk/SSD into the socket and gently slide into the connector.
4. Reinstall the screws of the hard disk bracket.

Connectivity

Front Panel Overview

The front panel features a power button, power LED, SATA LED, WiFi LED, memory card reader, headphone/audio out jack, microphone jack, USB 3.0 Type-C port, and a USB 3.0 port.

Rear Panel Overview

The rear panel includes a WiFi antenna connector, LAN (RJ45) ports, USB 3.1 ports, a USB 2.0 port, an HDMI port, a VGA port, a DisplayPort, and a power input (DC19V).

Setup Instructions

1. Connect the Wi-Fi antenna.
2. Connect to a wired home network.
3. Connect USB 3.1 devices.
4. Connect USB 2.0 devices.
5. Connect an HDMI display.
6. Connect a DisplayPort display.
7. Connect a VGA display.
8. Connect the power adapter and turn on the system.