ASUS ROG Ryujin Series Liquid CPU Cooler

Package Contents

The package includes:

• 1 x ROG RYUJIN 240 AiO cooler OR 1 x ROG RYUJIN 360 AiO cooler
• 1 x Intel Mounting Bracket
• 1 x Intel Backplate
• 1 x AMD Mounting Bracket
• Cooler pump cover
• *2/3 x 12cm NOCTUA IPPC fan
• 4 x Thumbscrew caps
• *8/12 x UNC 6-32x30mm Fan Screws
• 4 x LGA 115X/1366 Standoff Screws
• 4 x LGA 2011/2011-3/2066 Standoff Screws
• 4 x AM4 Standoff Screws
• *16/24 UNC 6-32x8mm Radiator Screws
• *16/24 x Washers

Note: The amount of packaged items may vary between models.

Installation Instructions

The illustrations in this section are for reference only, but the installation steps remain the same.

For Intel Motherboards

Skip steps A and B for LGA 20XX sockets.

1. Step A: Slide the Intel backplate pins according to the CPU socket of your motherboard. The Intel mounting bracket comes pre-installed on the AIO cooler.
2. Step B: Attach the Intel backplate to the bottom of the motherboard.
3. Step C: Install the standoff screws onto your motherboard. Ensure to use the correct standoff screws for your CPU socket.

For AMD Motherboards

Skip steps C and D for TR4 sockets.

1. Step C: Remove the four (4) screws from the pre-installed AMD heatsink mount, then remove the heatsink mount.
2. Step D: Install the AMD standoff screws onto your motherboard.

General Installation Steps

1. Install the fans onto the radiators, then install the fan and radiator combo to your PC chassis. Ensure to use the washers.
2. Align the AIO cooler with the standoff screws installed previously, then secure it with four (4) thumbscrew caps.
3. Connect the AIO cooler SATA power cable to an available SATA power connector.
4. Connect the fans to the fan connectors of the AIO pump. Ensure to connect to the 4-pin connector first to enable fan rotation detection.
5. Align the Cooler pump cover to the cover notches, then attach the Cooler pump cover to your AiO cooler.
6. Connect the USB cable to a 9-pin USB 2.0 connector on your motherboard.
7. Connect the AIO Cooler connector to the 4-pin AIO_PUMP or CPU_FAN connector on your motherboard.

Download Control Software

Please visit the product support page at http://www.asus.com to download and install the control software.

Support and FAQ

Q1: Why is my OLED not working after boot up?
A1: Please make sure your USB control cable and SATA cable are both connected to enable the OLED functions.

Q2: Why is the fan speed not detected when my radiator fan is spinning?
A2: Please switch the fan connector to the major connector of the Y cable from the pump. (Refer to P.18 for more details)

Q3: Why does my OLED screen not show the GIF or picture correctly?
A3: The OLED can only support GIFs and JPGs which are 160 x 128 pixels and/or 240 frames.