Resistex® CNATM168 User Notice
Product Type: Driver Detector
Voltage: 230/240V~50Hz/60Hz
HF System: 5.8GHz CW radar
Power Consumption: <0.5W
Time Delay Settings: 5s/1min/5min/10min (Note: Document contains conflicting time delay values; 5s/90sec/3min/10min also listed)
About the Device
This device is a detector that emits a high-frequency electromagnetic signal (5.8GHz) and receives its echo. It is recommended to perform tests to precisely adjust the detector's sensitivity. It is possible for the detector to detect through doors or thin walls if improperly adjusted.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION AND KEEP THIS NOTICE IN A KNOWN PLACE TO BE ABLE TO READJUST THE PRODUCT SETTINGS IF NEEDED.
Detection Range
This setting determines the effective range of the motion detector. Note: Reducing the sensitivity also reduces the detection range.
| Setting | Range |
|---|---|
| I | 100% |
| II | 75% |
| III | 50% |
| IV | 25% (or 10% in a second listing) |
Visual representation shows DIP switch settings for detection range.
Time Delay Before Dimming
This setting adjusts the duration the light stays on before dimming.
| Setting | Time |
|---|---|
| I | 5 seconds |
| II | 1 minute (or 90 seconds in a second listing) |
| III | 5 minutes (or 3 minutes in a second listing) |
| IV | 10 minutes |
Visual representation shows DIP switch settings for time delay before dimming.
Light Sensor (Daylight Threshold)
This allows the luminaire to switch off when the natural light level reaches the setting. The 'Disable' option keeps the light on regardless of ambient light.
| Setting | Lux Level |
|---|---|
| I | 5 lux (or Disable in a second listing) |
| II | 25 lux (or 50 Lux in a second listing) |
| III | 50 lux (or 15 Lux in a second listing) |
| IV | Disabled (or 5 Lux in a second listing) |
Visual representation shows DIP switch settings for the light sensor.
Time Delay Before Extinction
This setting adjusts the duration the light stays on before completely switching off.
| Setting | Time |
|---|---|
| I | 0 seconds |
| II | 1 minute (or 30 seconds in a second listing) |
| III | 10 minutes |
| IV | + ∞ (Infinite) |
Visual representation shows DIP switch settings for time delay before extinction.
Device Diagram and Connections
The diagram shows the components of the detector:
- LED: Indicator light.
- 230Vac Terminals: For power connection (Live 'L', Neutral 'N').
- Detection Zone: Adjustment for detection area.
- Time Delay: Adjustment for time delay settings.
- Crepuscular Sensor: Adjustment for light sensor sensitivity.
- Pre-warning of Extinction: Possibly related to the time delay function.
- Antenna: Part of the HF system.
- Fixation: Mounting point.
- DC Output: Output for connected load.
