Product Specifications
| Type of product: | HF Detector |
| Tension: | 230/240V~50Hz/60Hz |
| HF System: | 5.8GHz CW radar |
| Load Capacity: | 230V: 800W (resistive load), 400W (capacitive load), 150W (LED) |
Detection Specifications
| Detection Angle: | 30°~150° |
| Power Consumption: | <0.5W |
| Detection Distance: | 12m (max radius), 6m (max height) |
| Timing Options: | 5s/30s/1min/5min/10min/20min/30min |
Important Notice
Please read these instructions carefully before installation and keep this notice in a known place to be able to redo the product settings if needed.
This device is a detector; it emits a high-frequency electromagnetic signal (5.8GHz) and receives its echo. It is recommended to perform tests to precisely adjust the detector's sensitivity. It is possible that it detects through doors or thin walls if improperly set.
Detection Range
This setting determines the effective range of the motion detector. Note: reducing the sensitivity also reduces the detection range.
| Setting | Range | ||||
|---|---|---|---|---|---|
| I | ● | ○ | ○ | 100% | |
| II | ● | ● | ○ | 75% | |
| III | ● | ● | ● | 50% | |
| IV | ○ | ● | ● | 30% | |
| V | ○ | ○ | ● | 10% |
Indicator symbols: ● = ON, ○ = OFF. The ON/OFF indicators next to the table show the current state: [Up Arrow] for ON, [Down Arrow] for OFF.
Time Delay Before Extinction
Allows adjustment of the lighting duration after complete extinction of the luminaire.
| Setting | Time | |||||
|---|---|---|---|---|---|---|
| I | ● | ○ | ○ | 5 sec | ||
| II | ● | ● | ○ | 30 sec | ||
| III | ● | ● | ● | 1 min | ||
| IV | ○ | ● | ● | 5 min | ||
| V | ○ | ○ | ● | 10 min | ||
| VI | ○ | ○ | ○ | 20 min | ||
| VII | ○ | ○ | ○ | 30 min |
Indicator symbols: ● = ON, ○ = OFF. The ON/OFF indicators next to the table show the current state: [Up Arrow] for ON, [Down Arrow] for OFF.
Light Sensor
Allows the luminaire to be turned off when the natural light level reaches the required setting.
| Setting | Light Level | ||||
|---|---|---|---|---|---|
| I | ● | ○ | ○ | Disable | |
| II | ● | ● | ○ | 50 Lux | |
| III | ● | ● | ● | 20 Lux | |
| IV | ○ | ● | ● | 5 Lux | |
| V | ○ | ○ | ● | 2 Lux |
Indicator symbols: ● = ON, ○ = OFF. The ON/OFF indicators next to the table show the current state: [Up Arrow] for ON, [Down Arrow] for OFF.
Detector Unit Diagram Description
The detector unit is depicted with an antenna at the top. The detection zone is indicated, along with labels for 'T. allumage' (ignition time/trigger) and 'Crépusculaire' (twilight/dusk sensor). The unit has terminals for power input (220-240V) and output, labeled 'Alimentation' and 'Sortie' respectively.
