Quick Installation Guide
Applicable Model: AC1200M-U10
Repeater Mode
This device is a WiFi extender designed to expand your existing WiFi coverage. It supports dual-band WiFi (2.4GHz and 5GHz) and features an Ethernet port for wired connections.
The device has a compact design with multiple antennas for optimal signal transmission. It features an LED indicator and an Ethernet port.
| LED | Status | Description |
|---|---|---|
| Power | Solid On | The device is powered on. |
| WLAN | Blinking | The device is operating normally. |
| WPS | Blinking | WPS connection is in progress. |
| LAN | Solid On | An Ethernet device is connected. |
Ethernet/LAN Port: Used for connecting to a wired network or for wired client connections.
Power On: Plug the WiFi extender into a power outlet. The device will boot up automatically.
Connect to the Repeater:
- Connect your computer or smartphone to the WiFi extender's network (SSID: WiFi-Repeater or similar).
- Open a web browser and navigate to http://www.wifi-repeater.com or http://192.168.10.1.
- Log in with the default credentials (usually admin/admin).
Configure Repeater Mode:
- Select 'Repeater Mode'.
- Scan for available WiFi networks and select your existing WiFi network.
- Enter the password for your existing WiFi network.
- Click 'Apply' or 'Save'. The device will reboot and connect to your network.
Router Mode
Connect the WiFi extender's Ethernet port to your main router's LAN port using an Ethernet cable.
Follow the same steps as in Repeater Mode setup (steps 2 and 3 above), but select 'Router Mode' instead.
- You may need to configure WAN settings depending on your ISP.
- Set up your new WiFi network name (SSID) and password for the extender.
AP Mode
Connect the WiFi extender's Ethernet port to your main router's LAN port using an Ethernet cable.
Follow the same steps as in Repeater Mode setup (steps 2 and 3 above), but select 'AP Mode' instead.
- In AP mode, the device acts as an Access Point, broadcasting a WiFi signal using your wired network.
- You will typically set a WiFi name (SSID) and password.
Frequently Asked Questions (FAQ)
Q: What should I do if I cannot access the setup page?
A: Ensure your device is connected to the WiFi extender's network. Try clearing your browser's cache or using a different browser. You can also try resetting the device to factory defaults.
Q: How do I reset the WiFi extender to factory defaults?
A: Locate the reset button (usually a small pinhole) on the device. Press and hold it for about 10 seconds while the device is powered on. The device will reboot with factory settings.
Q: Why is the WiFi signal weak after setup?
A: Ensure the extender is placed in a location with a good WiFi signal from your main router. Avoid placing it near sources of interference like microwaves or thick walls.
Q: Can I use the Ethernet port to connect my computer?
A: Yes, the Ethernet port can be used to connect wired devices to your network, either in Repeater, Router, or AP mode.
Q: How do I update the firmware?
A: Check the manufacturer's website for firmware updates. Download the firmware file and follow the instructions on the setup page to upload it to the device.
