Philips Clock Radio 3000 Series R3306

Safety Information ⚠️

• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not block ventilation openings. Install per manufacturer instructions.
• Do not install near heat sources (radiators, stoves, amplifiers).
• Protect power cord from being walked on or pinched, especially at plugs and exit points.
• Use only manufacturer-specified attachments/accessories.
• Unplug during lightning storms ⚡ or when unused for long periods.
• Refer servicing to qualified personnel. Servicing needed if: power cord/plug damaged, liquid spilled, objects fallen in, exposed to rain/moisture ?️, not operating normally ❌, or dropped ⬇️.
• Battery Usage CAUTION: Prevent battery leakage (injury ?, property damage ?, or clock radio damage).
• Install batteries correctly (+/- as marked).
• Remove batteries if unit is unused for a long time.
• Battery ? not to be exposed to excessive heat (sun ☀️, fire ?).
• Clock radio not to be exposed to dripping or splashing ?.
• Do not place danger sources (e.g., liquid-filled objects, lit candles ?️) on clock radio.
• If Direct Plug-in Adapter plug is used as disconnect device, it must remain readily operable ✅.

Notice & Compliance

Changes/modifications not expressly approved by MMD Hong Kong Holding Limited may void user authority to operate.

TP Vision Europe B.V. declares this product complies with essential requirements and provisions of Directive 2014/53/EU. Declaration of Conformity available at www.philips.com/support.

Complies with European Community radio interference requirements. ??

Product designed/manufactured with high-quality, recyclable materials. ♻️

Disposal Information:

• ♻️ Symbol: Product must not be discarded as household waste ?️. Deliver to appropriate collection facility for recycling. Follow local rules. Correct disposal prevents negative consequences for environment ? and human health ❤️.
• ? Symbol: Product contains batteries covered by European Directive 2013/56/EU, not for normal household waste. Use local separate collection system for electronics and batteries. Correct disposal prevents negative consequences for environment ? and human health ❤️.

Getting Started & Setup Instructions

This section guides you through setting up your Philips Clock Radio.

1. Powering the Device

• Battery Installation: Open the battery compartment on the back. Insert 2 x 1.5V AAA R03 UM-4 batteries, ensuring correct polarity (+ and -) as marked. (See Page 1, Diagram 3).
• AC Power: Connect the AC adapter to the clock radio and plug it into a wall outlet.

2. Setting the Time

Follow these steps to set the current time:

1. Press and hold the "2 sec" button.
2. While holding "2 sec", press the "SET TIME/PRESET" button.
3. Use the "HR" (Hour) and "MIN" (Minute) buttons to set the correct time. (Display examples: 12:38, 6:00, 6:12. See Page 1, Diagrams 1-4).
4. Release the "SET TIME/PRESET" button. The time will now be displayed.

3. Setting the FM Radio

Tune into your favorite FM stations:

• Press the "TUN" button to tune to an FM station.
• Press and hold "TUN" for a few seconds to automatically scan for stations.
• Manually tune to a frequency (e.g., 87.5 MHz, 88.1 MHz) using the "TUN" button. (See Page 2 diagrams).
• To Save Presets: Tune to the desired station, then press and hold "SET TIME/PRESET" and select a preset number (P01, P02). (See Page 2 diagrams).

4. Setting Alarms

Set up to two alarms:

• Alarm 1 (AL1): Press "AL1". Press and hold "SET TIME/PRESET" while pressing "HR" and "MIN" buttons to set the alarm time (e.g., 7:30). Press "AL1" again to confirm. The alarm indicator will appear. (See Page 2 diagrams).
• Alarm 2 (AL2): Repeat the process using the "AL2" button.
• Snooze/Brightness: The "SNOOZE/BRIGHTNESS" button temporarily silences an alarm (snooze) or adjusts display brightness. (See Page 2 diagrams).
• 24-Hour Format: The clock can display time in 12-hour or 24-hour format. (See Page 2 diagram showing "24H").

5. Sleep Timer

Set the radio to turn off automatically:

• Press the "SLEEP" button.
• Use the "HR" and "MIN" buttons (or designated buttons) to select the sleep duration (e.g., 120, 90, 60, 30, 15 minutes). (See Page 2 diagram).
• Press "SLEEP" again to confirm.
• To turn off the sleep timer, press "SLEEP" until "OFF" is displayed.

Regulatory & Compliance Information

FCC Information (USA) ??

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IC-Canada ??

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

European Compliance ??

TP Vision Europe B.V. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.philips.com/support.

This product complies with the radio interference requirements of the European Community.